Abstract:Gas or liquid flow through small channels has become more and more popular due to the micro-electromechanical systems (MEMS) fabrication technologies such as micro-motors, electrostatic comb-drive, micro-chromatographs, micro-actuators, micro-turbines and micro-pumps, etc. The flow conditions in and around these systems are always recognized as typical transitional regimes. Under these conditions, the mean free path of gas molecules approaches the characteristic scale of the micro-devices itself, and due to the little collisions the heat and momentum cannot equilibrate between the wall and fluids quickly. Couette flow is a simple and critical model in fluid dynamics which focuses on the mechanism of the heat transfer in shear-driven micro-cavities or micro-channels. Despite numerous work on the numerical solutions of the Couette flow, how to propose stable and accurate slip boundary conditions in rarefied flow conditions still remains to be elucidated. In this paper, converged solutions for steady-state micro Couette flows are obtained by using conventional Burnett equations with a set of modified slip boundary conditions. Instead of using the physical variables at the wall, the modified slip conditions use the variables at the edge of the Knudsen layer based on a physically plausible assumption in literature that Knudsen layer has a thickness only in the order of a mean free path and molecules are likely to travel without collision in this layer. Numerical results for non-dimensional wall shear stress and heat flux are compared with those of the DSMC solutions. Although there are not much improvement in the accuracy by using this modified slip conditions, the modified conditions perform much better than the unmodified slip conditions for numerical stabilization. All results show that the set of conventional Burnett equations with second order modified conditions are proved to be an appropriate model for the micro-Couette flows.

An Effective Slip Boundary for Micro-Structured Surfaces Containing a Second Immiscible Fluid

The Effect of Slip Distribution on Flow Past a Circular Cylinder

Influence of Interfacial Coupled Flow on Slip Boundary over a Microstructured Surface

Simulation of Couette Flow Using Conventional Burnett Equations with Modified Slip Boundary Conditions

Modelling Slip Flow in Micro/nano Gaps with Moving Boundary

Effective slip over partially filled microcavities and its possible failure

Effective slip length of confined fluid with wavy fluid-solid interfaces

Influence of the Navier Boundary Wall Slip on Flow Patterns in Micro-Scale Cavity

Slip Boundary Conditions for Rough Surfaces

Arbitrary slip length for fluid-solid interface of arbitrary geometry in smoothed particle dynamics

Effective slip boundary conditions for flows over nanoscale chemical heterogeneities

Effective slip boundary conditions for arbitrary periodic surfaces: The surface mobility tensor

On the Boundary Slip of Fluid Flow

Three-Dimensional Simulations of Anisotropic Slip Microflows Using the Discrete Unified Gas Kinetic Scheme

Micro/Nano-Scale Fluid Flows On Structured Surfaces

Effective Boundary Slip Induced by Surface Roughness and Their Coupled Effect on Convective Heat Transfer of Liquid Flow

Investigation into Shear Flow in Micro/Nano Gap Based on Complicated Boundary Slip

Slip Boundary Condition for Lattice Boltzmann Modeling of Liquid Flows

Lattice Boltzmann Simulations of Liquid Flows in Microchannel with an Improved Slip Boundary Condition

Generalized Second-Order Slip Boundary Condition for Nonequilibrium Gas Flows