Insight on Ultrasonic Effect of Al Cu Aluminum Alloy Joints Fabricated by Ultrasonic Assisted Non-Thinning and Penetrating Friction Stir Welding

Dongrui Li,Huijie Liu,Shuaishuai Du,Yisong Gao,Yingying Zuo,Xuanmo Li

DOI: https://doi.org/10.1016/j.matchar.2023.113605

IF: 4.537

2024-01-01

Materials Characterization

Abstract:Al-Cu alloy joints of ultrasonic assisted non-thinning and penetrating friction stir welding (U-NTPFSW) and NTPFSW were prepared. The microstructure and mechanical properties of the joints were studied comparatively to elucidate the effect of ultrasonic. This study provided an in-depth understanding of the microstructure for-mation mechanism and strengthening mechanism of joints under the ultrasonic effect. Ultrasonics broadened the width of the stir zone (SZ) and stationary shoulder affected zone (SSAZ) by promoting the material plastic flow ability and changing the material flow at the weld root. The ultrasonic addition enhanced plastic heat production and promoted grain growth in SZ. Compared with NTPFSW, the SZ of both joints was dominated by continuous dynamic recrystallization (CDRX) and discontinuous dynamic recrystallization (DDRX) mechanisms, and geo-metric dynamic recrystallization (GDRX) grains were also present in U-NTPFSW. The mechanical properties of the joint were improved from 339 MPa to 348 MPa. Ultrasonics introduced numerous vacancies into the weld, which promoted the precipitation of the Al2Cu phase and increased the precipitated phase density of the thermal-mechanical affected zone (TMAZ). The interaction mechanism between the precipitated phase and dislocations was analyzed. The geometrically necessary dislocation (GND) density and residual stress of TMAZ were reduced due to ultrasonic vibration.