Abstract:The CIE color rendering (fidelity) index (CRI) has remained unchanged for over four decades. Most, if not all, of its components could be updated to more state-of-the-art methods. One of the most critical components of any color rendering (fidelity) metric is the test sample selection. This article therefore addresses the importance of uniform sampling of wavelength space to avoid selective optimizationthat is, taking advantage of the unequal contributions of different wavelength regions to the general color rendering scoreof light source spectral power distributions. It summarizes the development of a mathematical sample set with undistorted spectral sensitivity, the HL17 set. The set is used in a recently proposed update, the CRI2012 general color rendering index. To assess the impact of the spectrally uniform sample set on color fidelity scores, the CRI2012 index values for each of a set of 139 lamps were compared with those of the CIE CRI. In addition, the impact of updating the other components was investigated. A mean and maximum absolute difference of respectively 5.9 and 21.8 index units were found between the CRI2012 and CIE CRI, although the largest partrespectively 4.03 and 19.7 index unitswas shown to be the result of updating the color difference engine and the switch to the CIE 10 degrees observer. The analysis also indicated possible past spectral selective optimization of some warm-white tri-band fluorescent sources for high luminous efficacy of radiation (LER) and (just) sufficient CIE R-a values by taking advantage of the spectral nonuniformity of the CIE reflectance set. Adopting a spectrally uniform sample set in a color rendering metric therefore has important practical implications when designing light source spectra. Finally, possible updates and further improvements of the CRI2012 are briefly mentioned.

High Color Rendering Can Enable Better Vision without Requiring More Power

The Impact of Color Rendering on Visual Fatigue in Interior Zone of Tunnel

Redefining artificial lighting through spectral engineering of light sources for well-being

Perceptual Responses to Led Illumination with Colour Rendering Indices of 85 and 97

INFLUENCE OF LED COLOR TEMPERATURE ON LUMINANCE OF THE INTERIOR TUNNEL ZONE

Considerations in LED Spectral Design for Enhanced Color Quality

[Proper lighting for color vision testing: The TRUE COLOR LED lamp - an innovation in this field]

Spectral Optimization of White LED Based on Mesopic Luminance and Color Gamut Volume for Dim Lighting Conditions

A Paradox of LED Road Lighting: Reducing Light Pollution Is Not Always Linked to Energy Savings

Toward a Replacement of the CIE Color Rendering Index for White Light Sources

Luminous Efficacy of White LED in the Mesopic Vision State

LED Light with Enhanced Color Saturation and Improved White Light Perception.

Research of spectrum effects on color visual performance at mesopic condition

High color-rendering flat lamps using quantum-dot color conversion films

Optimising augmented reality projector light output to balance art conservation, colour quality and energy consumption

Evaluation of Light Sources Based on Visual Colour Rendering

LEDs: A Promising Energy-Saving Light Source for Road Lighting

EFFECT OF LIGHT LEVEL ON COLOR PREFERNECE AND SPECIFICAITON OF LIGHT SOURCE COLOR RENDITION

Several biological benefits of the low color temperature light-emitting diodes based normal indoor lighting source

A photon-recycling incandescent lighting device

The CRI2012 Color Fidelity Index and Its Practical Application