Abstract:Minimizing the mass and moment of inertia is a crucial objective in robot design. Especially for the biped humanoid robots, leg mass and moment of inertia severely affect the robot’s ultimate speed, motion stability, and interaction safety. The lightweight design for the legs of biped humanoid robots has been a hot but difficult research topic in recent decades. This paper will propose a new optimization approach for achieving lightweight design of biped humanoid robot legs. Firstly, the joint drivetrain dynamic model will be established, followed by the process of determining the selection criteria of motors and gearbox, and clarifying the calculation method of joint mass attributes. Secondly, the minimal total mass of the robot’s legs is taken as the goal to optimize, and the parameters related to the motor and gearbox models are the design variables. As the robot walks stably, the maximal walking speed that is close to the target speed is regarded as the constraint. A complex method is then implemented in a commercial mathematical software, the model to simulate robot dynamics is established in commercial dynamic software, and the dynamic simulation is completed using the three-dimensional linear inverted pendulum gait planning method. Finally, the Walker robot is used as an example to demonstrate the effectiveness of the proposed design optimization approach. The results show that the design optimization method can significantly reduce the total mass of the robot’s legs, reduce the torque requirements of the robot’s leg joints, and improve the stability of the robot’s motion. The optimization approach presented in this study is also important and applicable to the lightweight design of other categories of robots.

Leg Mass Influences the Jumping Performance of Compliant One-legged Robots

Stable and Fast Planar Jumping Control Design for a Compliant One-Legged Robot

Design and Analysis of the Leg Configuration for Biped Robots’ Spring-like Walking

Design and sequential jumping experimental validation of a musculoskeletal bipedal robot based on the spring-loaded inverted pendulum model

Influence of Leg Stiffness on Payload Capacity at High Speed

A unified model with inertia shaping for highly dynamic jumps of legged robots

Design, Optimization, and Experiment on a Bioinspired Jumping Robot with a Six-Bar Leg Mechanism Based on Jumping Stability

Hopping Motion on Heavy-Legged Bipedal Robot Based on SLIP Model and Whole Body Control

Modeling, comparison and evaluation of one-DOF six-bar bioinspired jumping leg mechanisms

Compliant Bipedal Walking Based on Variable Spring-Loaded Inverted Pendulum Model with Finite-sized Foot

Design and Implementation of Symmetric Legged Robot for Highly Dynamic Jumping and Impact Mitigation

Influence of "J"-Curve Spring Stiffness on Running Speeds of Segmented Legs During High-Speed Locomotion.

Leg Configuration Analysis and Prototype Design of Biped Robot Based on Spring Mass Model

How Do the Compliant Legs Affect Walking Stability.

Rigid-flexible coupling dynamic modeling and performance analysis of a bioinspired jumping robot with a six-bar leg mechanism

Lightweight Design Optimization for Legs of Bipedal Humanoid Robot

The generalized spring-loaded inverted pendulum model for analysis of various planar reduced-order models and for optimal robot leg design

Stability and robustness of biped passive dynamic robot based on hip mass

Dynamic compliance of energy-saving legged elastic parallel joints for quadruped robots: design and realization

Dynamic model and performance analysis of rigid-flexible coupling four-bar leg mechanism for small scale bio-inspired jumping robot

An Alternating Optimization Approach Integrating Linkage Design with Motion Planning for Jumping Robot