Influence of Short-Time Annealing on the Evolution of the Microstructure, Mechanical Properties and Residual Stress of the C19400 Alloy Strips

Jingzhao Yang,Kun Bu,Yanjun Zhou,Kexing Song,Shuang Yu,Tao Huang,Xiao Peng,Haitao Liu,Yibo Du

DOI: https://doi.org/10.1016/j.jallcom.2023.168705

IF: 6.2

2023-01-01

Journal of Alloys and Compounds

Abstract:The changes in the tensile strength, microhardness, electrical conductivity and residual stress of the C19400 alloy strips annealed at 100–500 ℃ for a short time were studied. The coordinated control mechanism of the high strength and low residual stress of the C19400 alloy strips by short-time annealing was revealed. The results show that annealing at 200 °C can maintain high strength and reduce the residual stress. When annealed at 200 °C, the tensile strength is only 0.6 % lower than that of the original state, while the residual stresses of transverse direction and rolling direction are 47.2 % and 90.9 % lower than that of the original state, respectively. Reducing the volume fraction of Brass, Copper and S textures is beneficial for controlling the residual stress of the C19400 alloy. Most remarkably, compared with the original state, after annealing at 300 ℃, the tensile strength and microhardness increase from 428 MPa to 432.5 MPa and 141.6 HV to 144.8 HV, respectively. When annealing at 400–500 ℃, the tensile strength and microhardness decrease significantly. The main influencing factor of annealing hardening and softening is dislocation density. In the former, dislocation blocking increases the dislocation density during low-temperature annealing, while in the latter, recovery and recrystallization occur, and the dislocation density decreases after high-temperature annealing. The results provide a reference for improving the performance of ultrathin C19400 alloy strips.