Automatic Maize Seeding Machine Watering Spray Angle Determination by Using a Novel Index
Jiangfan Yu,Zhao Zhang,Xiaohang Liu,Kuifan Chen,Yunxia Li,Cannayen Igathinathane,Xiqing Wang,Man Zhang,Han Li,Tuan Ha
DOI: https://doi.org/10.1016/j.compag.2024.109234
IF: 8.3
2024-01-01
Computers and Electronics in Agriculture
Abstract:Seeding is a significant operation in maize cultivation, which is mostly manual, so the germination rate is key information. We developed an automatic seeding machine that performs sand filling, seed placement, watering, and seed covering, where watering is a critical operation. Spray angle, a key factor influencing the watering process and seed germination characteristics, was determined using image analysis. The current system 's spray angle includes three settings (35 degrees , 55 degrees , 75 degrees ), and its performance was evaluated in terms of watering area ratio (WAR, small watering area can result in insufficient moisture and wetting area for the seeds), seed pattern distortion (SPD, irregular seed pattern would interfere with the detection of germinated seedlings), sand surface deformation (SSD, a measure of moisture content in sand due to its surface undulations), and water spraying efficiency (WSE, a small value indicates poor system performance). For WAR, SPD, and SSD evaluation, image data of a tray loaded with sand and planted with seeds using RGB-D (color [RGB] coupled with depth [D]) were collected before and after watering, followed by data pre-processing (general image segmentation). An empty tray was used to evaluate the WSE by measuring its mass before and after watering. For small (35 degrees ), medium (55 degrees ), and large (75 degrees ) spray angles, the WAR was 87.2 %, 96.4%, and 99.3 %; the average seed displacement was 20.0, 14.7, and 3.1 mm/tray; the average volume of the puddle was 11.3, 0, and 0 cm 3 ; and the WSE was 9.49, 8.89, and 5.13 g/s, respectively. For a comprehensive and objective comparison of the three spray angles, the spray angle performance index (SAPI) was proposed, and the corresponding values of SAPI for spray angles were 0.11, 0.47, and 0.39, respectively. It is concluded that the medium spray angle (55 degrees ) generates the most satisfactory performance and should be applied in practical applications. Furthermore, the developed workflow for systematically evaluating the sprayer 's performance has the potential to be used as an automatic and objective evaluation method for various spray nozzles and angle settings from the automatic seeding and germination standpoint.