Stress-Dependent Characteristics of Coal Permeability in Gasification Zone of Underground Coal Gasification

Yufeng Zhao,Zhen Dong,Yanpeng Chen,Hao Chen,Junjie Xue,Shanshan Chen,Mengyuan Zhang,Yan Peng
DOI: https://doi.org/10.56952/arma-2023-0389
2023-01-01
Abstract:ABSTRACT Underground coal gasification (UCG) is an environment friendly way to produce coal resource and its efficiency depends on gas flow through porous medium. Therefore, the flow behavior especially the stress-dependent permeability characteristics are important topics for the UCG. The stress-dependent permeability characteristics in combustion zone are widely investigated, while, ones in gasification zone are rarely investigated but they are important for gas flow from injection wells to production wells. In this study, first, permeability tests for coal after heating below 500°C were conducted under various confining pressure. Secondly, microscopic structures of coal samples after heating were observed by the scanning electron microscope (SEM). Finally, the stress-dependent permeability characteristics of coal after heating were discussed and a model involving thermal-mechanical effect was built. The main results show that (1) permeability decreases and then increases with temperature. The increase magnitude of permeability becomes obvious at 200°C and it rises significantly up to 430% at 500°C. (2) the stress-dependent behavior of permeability decreases with temperature. The decrease magnitude can be 60%. (3) samples’ microscopic structures are affected by coal pyrolysis after heating and further affect permeability characteristics. Before 200°C, obvious change of microscopic structure is width increase of existing microscopic fractures. After 200°C, lots of new microscopic fractures are generated and macroscopic fractures may also be generated in some samples. (4) considering impacts of stress, thermal swelling and microscopic fracture generated by coal pyrolysis on permeability, a model is generated and its mean error is less than 4.3%. INTRODUCTION Underground coal gasification (UCG) technology, as a cutting-edge technology for clean coal, has developed rapidly in recent years and has also been the focus of academic and industrial circles[1]. This technology can mine deep and ultra-deep coal seams that cannot be mined by ordinary mining technology. The coal reserves of these coal reservoirs are often much higher than those of the middle and shallow coal seams. In addition, since the redox reaction occurs in the formation, the raw coal is converted into clean energy based on CO, CH4, and H2 in the original position[2]. This process leaves the ash produced by gasification in the ground and avoids environmental pollution. It also saves the cost of transporting coal to the ground under normal mining conditions [3].
What problem does this paper attempt to address?