Abstract:NbMoTaW and VCrTaW high-entropy alloys (HEA) coatings with near-equal atomic ratios were deposited onto the T91 substrate by magnetron sputtering. The two HEA coatings and the T91 substrate were irradiated to the peak damage 50 displacements per atom (dpa) and 100 dpa using 2.7 MeV Si2+ at 550 °C. X-ray diffraction (XRD), Scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy dispersive X-ray spectroscopy (EDS) and nanoindentation techniques were used to study the changes in grain morphology, microstructure, element distribution and hardness before and after irradiation. The results showed that the grain structure was stable and the coatings were closely bonded to the substrate after irradiation. The elements (Ta and W) near the grain boundary in NbMoTaW coating were depleted before irradiation, but they became homogenized after irradiation. A large number of dislocation loops were observed in both the T91 substrate and HEA coatings after irradiation, the HEA coatings significantly increased the doses required for the full evolution of the dislocation loops. With the increase of damage doses, the dislocation loops size of HEA coatings increased and the number density decreased. The size of the dislocation loops of the two coatings was similar, while the number density of the dislocation loops of NbMoTaW coating was lower than that of VCrTaW coating. Both HEA coatings were significantly hardened after irradiation and the hardening rate of NbMoTaW coating was lower than that of VCrTaW coating. Interestingly, the hardening rate of 50 dpa was higher than 100 dpa for both HEA coatings, which was determined by softening factor and hardening factor in the irradiation process. Based on the defects and hardening rate caused by irradiation, it was preliminarily concluded that NbMoTaW coating had better irradiation resistance, and the above results provide an important reference for the subsequent optimization of lead-based fast reactors structural materials.

Microstructures and Hardening Effects of Refractory High Entropy Alloys Irradiated by Proton & He Ion Dual Beam

Irradiation-Hardening Model of TiZrHfNbMo0.1 Refractory High-Entropy Alloys

Effect of He-ions irradiation on the microstructure and mechanical properties of TiTaNbZr refractory medium-entropy alloy film

Irradiation Behaviors of Two Novel Single-Phase Bcc-Structure High-Entropy Alloys for Accident-Tolerant Fuel Cladding

Fracture Toughness Investigations of an Ion‐Irradiated Nanocrystalline TiZrNbHfTa Refractory High‐Entropy Alloy

Dislocation loops, segregation and hardening induced by high-dose ion irradiation of NbMoTaW and VCrTaW high-entropy alloy coatings on the T91 substrate

The Influence of Phase Formation on Irradiation Tolerance in a Nanocrystalline TiZrNbHfTa Refractory High‐Entropy Alloy

Irradiation damage behavior of the non-equal atomic AlNbMoZrB high-entropy alloy

Irradiation Damage and Hardening in Pure Zr and Zr-Nb Alloys at 573 K from Self-Ion Irradiation

Microstructural Evolution and the Irradiation Sensitivity of Different Phases of a High Nb-Containing TiAl Alloy under He Ions Implantation at Room- and Elevated Temperatures

A comparative study of irradiation response in amorphous TaTiWVCr refractory high entropy alloy with the counterpart of tungsten films

Irradiation damage versus lattice distortion in AlNbTiVCrx (x = 0, 0.5, 1) high-entropy alloys from first-principles calculations and irradiation experiments

Microstructural evolution and hardening effect in low-dose self-ion irradiated Zr-Nb alloys

Enhanced plasticity in a Zr-rich refractory high-entropy alloy via electron irradiation

Effect of Oxidation on Radiation Shielding Capacity of ZrNbTaMoW Refractory High Entropy Alloys (RHEA) for Nuclear Reactor Applications: Experimental and Theoretical Assessment

He-ion Irradiation Effects on the Microstructures and Mechanical Properties of the Ti-Zr-Hf-V-Ta Low-Activation High-Entropy Alloys

Microstructure and micromechanical responses of bulk nanostructured high entropy alloy after heavy-ion irradiation at 500°C

Effects of Nitrogen Doping on Microstructures and Irradiation Resistance of Ti–Zr–Nb–V–Mo Refractory High-Entropy Alloy

Microstructures, mechanical properties, and irradiation tolerance of the Ti–Zr–Nb–V–Mo refractory high-entropy alloys

Effects of He-ion Irradiation on the Microstructures and Mechanical Properties of the Novel Co-free VxCrFeMnNiy High-Entropy Alloys

Enhanced helium ion irradiation tolerance in a Fe-Co-Ni-Cr-Al-Ti high-entropy alloy with L1 2 nanoparticles