Experimental Study on Flexural Behavior of Assembled U-shaped Steel–Concrete Composite Beams

Ran He,JiXin Wang,ZhangQi Hu,ShenYun Liu,Hui Li

DOI: https://doi.org/10.25103/jestr.163.06

2023-01-01

Journal of Engineering Science and Technology Review

Abstract:The open U-shaped beam section of the traditional U-shaped steel-concrete composite beam has limited restriction on internal concrate, and formwork cast-in-place on the upper concrete slab is required on site, leading to a low assembly rate.A novel assembled U-shaped steel-concrete composite beam is proposed to strengthen the restriction of the lower U-shaped steel and improve its assembly rate.In accordance with the connection mode between the lower box beam and the upper floor slab, six full-scale simply supported specimens were designed considering the single and combined arrangement of three types of shear connectors: joint bar, truss, and stud.A destructive loading test was carried out under positive bending moment to compare and analyze the bending capacity, load-displacement curve, failure model, and strain distribution law of new members with different types of shear connectors.Results show that the U-shaped steel and concrete in the composite beam exhibit good synergistic effect, which can effectively avoid the overall instability and local buckling failure of the U-shaped steel.Under the action of positive bending moment, stress can be roughly divided into three stages: elasticity (0-0.7 Pu), weak elasticity (0.7-0.9 Pu), and elastoplasticity.The ultimate failure mode of composite beam members with shear connectors without studs is a ductile failure, whereas that with an arrangement of stud shear connectors is a plastic failure.The ultimate load of the member with truss welded to steel beam+joint bar (5-TJ) can increase by 11.5% and 33.3% compared with that with joint bar (1-J) and steel truss (2-T), respectively, thereby effectively improving the flexural behavior of the novel assembled U-shaped steel-concrete composite beam.Meanwhile, the member presents a strong ductility deformation capacity, and the ductility coefficient reaches 4.22.This shear connector form is excellent for this new type of member.The study provides a good reference for selecting shear connectors in the design of assembled composite beams.