Abstract:The National Synchrotron Radiation Laboratory is planning to build a 2.2 GeV diffraction-limited storage ring, the Hefei Advanced Light Facility (HALF), with a 6BA lattice structure and a large number of longitudinal gradient bends (LGBs). In order to increase the radiated photon energy to the hard X-ray band and to reduce the natural emittance, a superconducting longitudinal gradient bend (SLGB) magnet is planned to be used on HALF in the future, which requires a magnetic field integral of 0.40 T center dot m over a length of 0.46 m and a peak field of about 5 T. A SLGB has many structural parameters, such as the geometric parameters of the superconducting coils and the thickness of the yoke, etc. Their influence on the magnetic field distribution has been studied, although the computation of the 3D magnet model is very slow. Considering the longitudinal field variation, the vertical gap limitation, the field homogeneity requirement and the critical current of the superconducting wire, a method is developed to simplify the 3D magnet simulation by a corresponding 2D model, so that the longitudinal magnetic field profile of a 3D model can be approximately calculated in a 2D model with faster speed. Due to the faster calculation speed of 2D models, a Mathematica-based optimization program is developed and relatively good structural parameters for the HALF SLGB are found by the program. The simulation results show that the physical design requirements can be well met. The electromagnetic design for the HALF SLGB magnet is based on the current ???? level of NbTi superconductor due to its excellent mechanical performance.

Bunch Lengthening of the HALF Storage Ring in the Presence of Passive Harmonic Cavities

Periodic Transient Beam Loading Effect with Passive Harmonic Cavities in Electron Storage Rings

Bunch lengthening affected by the short-range effect of resonant modes in radio-frequency cavities

Multiple-bunch-length operating mode design for a storage ring using hybrid low alpha and harmonic cavity method☆

LOW Q CAVITY BPM STUDY FOR THE BEAM POSITION MEASUREMENT OF NANOSECOND SPACED ELECTRON BUNCHES *

A method of bunch by bunch measurement at nanoseconds interval by using cavity beam position monitors

Lifetime increase using a passive higher harmonic cavity for Hefei Light Source Ⅱ

Design and Simulation of a high order mode cavity bunch length monitor

Tracking Simulations for the HLS- II with a Passive Harmonic Cavity in the Symmetric and Asymmetric Fill Patterns

Design and tuning of S-band traveling wave accelerating structures for Hefei Advanced Light Facility

Equilibrium of an Arbitrary Bunch Train in the Presence of Multiple Resonator Wake Fields

Studies of bunch lengthening at the BEPC

Terahertz scale microbunching instability driven by nonevaporable getter coating resistive-wall impedance

Bunch-lengthening theory including wiggler effects

The Longitudinal “trapping” Phenomenon in the Simultaneous Acceleration of Intense H+ and H− in an RFQ

Cavity-based bunch length measurement study for the Super Tau-Charm Facility transport line

Simulation studies on compensation for space-charge-induced half-integer and 3rd-order resonance crossing in HIAF-BRing

A Code for Bunch Lengthening Simulation

Study of Robinson Instabilities with A Higher-Harmonic Cavity for the Hls Phase Ii Project

Broadband Impedance Calculations and Single Bunch Instabilities Estimations of of the HLS-II Storage Ring

Electromagnetic design study of a superconducting longitudinal gradient bend magnet based on the HALF storage ring