Abstract:Insight of thermal behaviour of lithium-ion batteries under various operating conditions is crucial for the development of battery management system (BMS). Although battery thermal behaviour has been studied by published models, the reported modelling normally addresses either normal operation or thermal runaway condition. A comprehensive electro-thermal model which can capture heat generation, voltage and current variation during the whole process from normal cycling to thermal runaway should be of benefit for BMS by evaluating critical factors influencing potential transition to thermal runaway and investigating the evolution process under different cooling and environment conditions. In this study, such a three-dimensional model has been developed within the frame of open source computational fluid dynamics (CFD) code OpenFOAM to study the electrical and thermal behaviour of lithium-ion batteries (LIBs). The equations governing the electric conduction are coupled with heat transfer and energy balance within the cell. Published and new laboratory data for LiNi0.33Co0.33Mn0.33O2/Li1.33T1.67O4 (LNCMO/LTO) cells from normal cycling to thermal runaway have been used to provide input parameters as well as model validation. The model has well captured the evolution process of a cell from normal cycling to abnormal behaviour until thermal runaway and achieved reasonably good agreement with the measurements. The validated model has then been used to conduct parametric studies of this particular type of LIB by evaluating the effects of discharging current rates, airflow quantities, ambient temperatures and thickness of airflow channel on the response of the cell. Faster function losses, earlier thermal runaway and higher extreme temperatures were found when cells were discharged under higher current rates. The airflow with specific velocity was found to provide effective mitigation against over-heating when the ambient temperature was below 370 K but less effective when the ambient temperature was higher than the critical value of 425 K. The thickness of airflow channel was also found to have critical influence on the cell tolerance to elevated temperatures. These parametric studies demonstrate that the model can be used to predict potential LIB transition to thermal runaway under various conditions and aid BMS.

A Fully Coupled Thermomechanical Analysis of Lithium-Ion Batteries with Total Heat Generation Rate

Simulation Study on Heat Generation Characteristics of Lithium-Ion Battery Aging Process

Electro-Thermal Modeling of a Hollow Structure Design of Cylindrical Lithium-Ion Battery

Electrochemical-Thermal-Mechanical Coupling Analysis of Lithium-Ion Batteries under Fast Charging

A Review on the Research of Thermal Models for Lithium Ion Battery Cell

Thermo‐mechanical coupling analysis of a cylindrical lithium‐ion battery with thermal radiation effect in generalized plane strain condition

Full-cycle electrochemical-thermal coupling analysis for commercial lithium-ion batteries

Coupled Electrochemical-Thermal-Mechanical Modeling and Simulation of Lithium-Ion Batteries

Analysis of Heat Generation in a Li-Ion Battery Based on a Multi-Scale and Electrochemical-Thermal Coupled Model

Research on Temperature Non-Uniformity of Large-Capacity Pouch Lithium-Ion Batteries: Modeling, Analysis, and Optimization

Insight into Heat Generation of Lithium Ion Batteries Based on the Electrochemical-Thermal Model at High Discharge Rates

Modelling Electro-Thermal Response of Lithium-Ion Batteries from Normal to Abuse Conditions

Thermal Analysis of Lithium-Ion Batteries

Evaluating the heat generation characteristics of cylindrical lithium-ion battery considering the discharge rates and N/P ratio

Thermal modelling, simulation and investigation of cylindrical lithium‐ion batteries—A comprehensive study

Electro-thermal Modeling and Experimental Validation for Lithium Ion Battery

A Multiphysics Model Simulating the Electrochemical, Thermal, and Thermal Runaway Behaviors of Lithium Polymer Battery

Experimental and Analytical Study on Heat Generation Characteristics of a Lithium-Ion Power Battery

Thermal Analysis of a Cylindrical Lithium-Ion Battery

Numerical Study on Heat Generation Characteristics of Charge and Discharge Cycle of the Lithium-Ion Battery

An Investigation on Deformation Behavior of Lithium-ion Battery Based on the Electrochemical-Thermal-mechanical Coupling Model