The Lyα Non-Detection by JWST NIRSpec of a Strong Lyα Emitter at Z=5.66 Confirmed by MUSE

Haochen Jiang,Xin Wang,Cheng,Xu Kong,Qianqiao Zhou,Xiao-Lei Meng,Xianlong He,Tucker Jones,Kristan Boyett
DOI: https://doi.org/10.3847/1538-4357/ad61db
IF: 5.521
2024-01-01
The Astrophysical Journal
Abstract:The detections of Ly alpha emission in galaxies with redshifts above 5 are of utmost importance for constraining the cosmic reionization timeline, yet such detections are usually based on slit spectroscopy. Here we investigate the significant bias induced by slit placement on the estimate of Ly alpha escape fraction (f(esc)(Ly alpha)) by presenting a galaxy (dubbed A2744-z6Lya) at z = 5.66, where its deep JWST/NIRSpec prism spectroscopy completely misses the strong Ly alpha emission detected in the MUSE data. A2744-z6Lya exhibits a pronounced UV continuum with an extremely steep spectral slope of beta=-2.640(-0.008)(+0.008), and it has a stellar mass of similar to 10(8.75)M(circle dot), a star formation rate of similar to 5.95 M-circle dot yr(-1), and a gas-phase metallicity of 12+log(O/H)similar to 7.90. The observed flux and rest-frame equivalent width of its Ly alpha from MUSE spectroscopy are 1.2 x 10(-16) erg s(-1) cm(-2) and 75 & Aring;, equivalent to f(esc)(Ly alpha)=42%+/- 1%. However, its Ly alpha nondetection from JWST NIRSpec gives a 5 sigma upper limit of <5%, in stark contrast to that derived from MUSE. To explore the reasons for this bias, we perform spatially resolved stellar population analysis of A2744-z6Lya using the JWST NIRCam and HST imaging data to construct 2D maps of star formation rate, dust extinction, and neutral hydrogen column density. We find that the absence of Ly alpha in the slit regions probably stems from both the resonance scattering effect of neutral hydrogen and dust extinction. Through analyzing an extreme case in detail, this work highlights the important caveat of inferring f(esc)(Ly alpha) from slit spectroscopy, particularly when using the JWST multiplexed NIRSpec microshutter assembly.
What problem does this paper attempt to address?