Abstract:Composite hydrogels of polyacrylamide-graft-polyaniline possessing both good mechanical strength and excellent electrical conductivity were prepared through a two-step polymerization route. Firstly, acrylamide (Am) and N-(4-aminophenyl) acrylamide (APAm) were radically copolymerized through Co-60 gamma-irradiated initiation in aqueous solution to form P (Am-co-APAm) hydrogels, of which the aminophenyl side groups facilitated the following graft polymerization of aniline. Secondly, after the lyophilized P (Am-co-APAm) hydrogels were re-swelled in aniline aqueous solution, aniline absorbed in the macroporous hydrogels underwent the oxidation coupling graft polymerization with aminophenyl side groups of P (Am-co-APAm) to result in P(Am-co-APAm)-g-PANI composite hydrogels. As expected, the produced polyaniline was naturally deposited onto the pore wall of P (Am-co-APAm) hydrogels, leading to the formation of inter-connected conductive pathway. Fourier transfer infrared spectroscopy, combined with the repeated removal of possible homopolyaniline with N-methylpyrilidone, confirmed the successful grafting. To modulating the mechanical properties, the influences of radical polymerization parameters were investigated. By changing radiation duration and dose rate, it was found that the gel fraction (GF) of P (Am-co-APAm) hydrogels increased with the increment of irradiation dose, while swelling degree (SD) had the maximum value under medium irradiation dose,reflecting that both monomer conversion and crosslinking degree affected the GF and SD of P (Am-coAPAm) hydrogels. With the increase in monomer concentration, GF was kept going up and levelled off at 1. 5 c(o) while SD kept going down and levelled off at the same monomer concentration. The tensile strength and elongation at break of P (Am-co-APAm) hydrogels decreased, but elastic modulus increased, reflecting the cooperative impact of crosslinking degree and polymer produced. Interestingly, as observed by scanning electron microscopy,the hydrogels prepared in neutral water had the open and macro-porous morphology while those obtained in HC1 solution had no distinct pores. For both hydrogels, TEM images showed no separated polyaniline particles located in the hydrogel pores and the thickness of pore wall obviously increased, indicating the formation of continuous polyaniline layer on the previous pore wall. Therefore, after being doped with HC1, P(Am-co-APAm)-g-PANI composite hydrogels exhibited excellent conductivity as high as 7 similar to 10 S/cm, which exceeded most of the reported values for polyaniline-containing hydrogels.

Versatile Functionalization of Polyester Hydrogels with Electroactive Aniline Oligomers Part A Polymer Chemistry

Synthesis and Tunable Properties of Oligoaniline-Functionalized Polyamides

Preparation and Investigation of Conductive Hydrogels of Polyacrylamide-g-Polyaniline

SYNTHESIS AND CHARACTERIZATION OF ELECTROACTIVE GRAFT COPOLYMER OF POLY(L-GLUTAMIC ACID)-g-ANILINE TETRAMER

Synthesis, characterization and in vitro degradation of a new family of alternate poly(ester-anhydrides) based on aliphatic and aromatic diacids

Facile Synthesis of Functional Poly( Ε -Caprolactone) Via Janus Polymerization

Synthesis, Characterization, and Microbial Degradation Behavior of Hydrogel Based on Poly(ε-caprolactone) and Methacrylic Anhydride

Thermosensitive Poly(N-isopropylacrylamide-co-acrylonitrile) Hydrogels with Rapid Response

Hierarchical Nanostructured Conducting Polymer Hydrogel with High Electrochemical Activity

Poly(ethylene Glycol)s with a Single Cinnamaldehyde Acetal Unit for Fabricating Acid-Degradable Hydrogel.

Preparation of amphoteric double network hydrogels based on low methoxy pectin: Adsorption kinetics and removal of anionic and cationic dyes

Synthesis of Functional Polycaprolactones Via Passerini Multicomponent Polymerization of 6-Oxohexanoic Acid and Isocyanides

Synthesis and Characterization of Polyhydroxyalkanoate Organo/Hydrogels.

Adjustable degradation properties and biocompatibility of amorphous and functional poly(ester-acrylate)-based materials.

Acid-mediated strategies designed for stretchable and durable polyacrylamide/sodium alginate dual-network hydrogels toward flexible capacitors and wearable sensors

PAAm and PEDOT/PSS hydrogel as potential electroactive devices: evaluation of surface and hydrophilic properties

Synthesis, characterization and application of oligomeric proanthocyanidin-rich dual network hydrogels

Degradability of Poly(epsilon-caprolactone) Bearing Pendant Carboxyl Groups

Design of functional hydrogels using smart polymer based on elastin-like polypeptides

Tough and Conductive Hybrid Hydrogels Enabling Facile Patterning.

Synthesis and Characterization of Lignosulfonate- Graft -Poly (acrylic Acid)/hydroxyethyl Cellulose Semi-Interpenetrating Hydrogels