Discovery of Na and Zn Bearing Spinel in the Rock Cuttings from the Main Hole, Chinese Continental Scientific Drilling(CCSD)

Yunfei Ren,Jingsui Yang,Jiang Shu,H. K. Mao,Z. Zhang
2006-01-01
Abstract:In the rock cuttings from the main hole, CCSD, Na- and Zn bearing spinel occurred as exsolution lamella in ilmenite and magnetite. The mineral is about 5 -60μm in width and 2 -3μm in length, composed of MgO 17. 143 -22. 337wt% , Al2O363. 646 -66. 492wt% , FeO 9. 784 - 13. 924wt% , ZnO 1. 649 -6. 386wt% , Na2O 0. 029 -0. 219wt% , where Na2O and ZnO are positively in different grains. By x-ray analysis of synchrotron light source, the spinel is cubic symmetry with space group of Fm3m and crystal cell parameter of a =0. 83781 nm. With the fact that the spinel is associated with ilmenite, magnetite, garnet (pyr =50 -58mol% ) and the garnet is retrograded into orthopyroxene and Mg-chlorite, the spinel should be derived from ultramafic, and experienced amphibolite facies metamorphism. The phenomenon of miscibility gap and exsolution texture are widely occurred in the oxide minerals between Mt-Usp , Mt-Spl and Mt-Ilm. According to the known petrologic experiments of Mt-Usp binary system and Ilm-Gk-Hem ternary system, the oxygen fugacity of the rocks in the main hole is low and forming temperature is at least over 720℃. The ferro-titanium oxides exsoluted during ultramafic magma crystallization, but later in ultrahigh pressure metamorphism may be formed solid solutions and exsoluted again after temperature decrease.
What problem does this paper attempt to address?