Remote Sensing Retrieval Model on Soil Moisture Content of Tidal Flat Based on Measured Spectra

Huan Li
2013-01-01
Abstract:Taking one piece of tidal flat as study area, which is located at the south of Dafeng port in Jiangsu province, soil samples were collected from the surface soil of 5 cm depth along 16 transects in 2 tidal mudflats at low tides in June of 2008. These sampling points were distributed between the bare surface near shore and the low tidal line offshore. In total, 162 soil samples were collected. The positions of these samples were determined using a differential GPS unit. Twenty five samples were selected from the overall samples as there is little difference in the spectra for the same type of soil. This selection was based on the consideration of soil type and its spatial distribution. This sub-group samples can representative the major characteristics of the whole samples both geographically and in soil substances. Spectral measurements were taken in an outdoor setting from the nadir at 10 cm high using a full-range (350-2 500 nm) spectrometer with a 1° view angle. Samples were placed under natural light. The measured reflectance was calibrated using a white spectral on panel. The 25 soil samples were spread out evenly in 9 cm round culture dishes to a depth of 0.5 cm. These dishes had been previously weighed and painted pitch black to avoid contamination. Distilled water was added to these culture dishes until soil moisture content reached full saturation. Under natural conditions moisture is gradually lost from the soil, so reflectance was measured at a short time interval while samples were weighted simultaneously to an accuracy of 0.001 g using an analytical balance. Instantaneous moisture content was calculated as a ratio of the lost (evaporated) water weight to oven dried sample mass minus the weight of the culture dish. The results showed that under dry condition, the much smaller particle size of intertidal soil is, the much smoother of soil surface becomes. In this case the reflectance of soil was relatively higher. However, when water come out in the soil, above phenomenal will be disappeared as electromagnetic wave is absorbed by water severely and has much further influence than that only from particle size. With the increase of water content, the unit area of soil surface would hold more water which leads to stronger absorption to electromagnetic wave, correspondingly, the reflectance of soil show a decreasing trend. It is easily found at VNIR (visible and near-infrared radiometer) wavebands and absorption, especially at those positions with longer wavelength. Compared with other wavebands of TM sensor, TM7 has the longest wavelength, which is correspond to 2 220 nm approximately, so it is more sensitive to the variation of soil moisture, meanwhile statistical analysis provided that the reflectance of TM7 enjoys high correlation with moisture content and the prediction model constructed via this sensitive band possesses potential to retrieve moisture content. One reflectance-moisture model was constructed according to the difference between the 490 nm and 2 220 nm spectral reflectance also had good predictive ability for moisture detection and it could be also used to eliminate the influence of background.
What problem does this paper attempt to address?