Novel C hain S tructures of S ulfur at Hi gh Pr essure
O. Degtyareva,E. Gregoryanz,M. Somayazulu,P. Dera,H. K. Mao,R. J. Hemley
2005-01-01
Abstract:Introduction Polymorphism of sulfur has been studied over the years by a wide range of techniques. Different experiments, however, have produced conflicting results, mostly because all structural studies on lower pressure phases have been performed only on quenched samples [1]. In fact, some 12 solid and 5 liquid phases have been reported, making the phase diagram of sulfur one of the most complicated among the elements [2]. In situ high-pressure diffraction studies on metallic phase of sulfur report a base-centered orthorhombic (bco) structure above 86 GPa [3,4], which transforms at 162 GPa to a β-Po structure [4]. These metallic phases of sulfur are isostructural with the high-pressure metallic phases of the heavier group-VI elements Se and Te [5-7]. The crystal structure of sulfur in the intermediate pressure range below metallization is unclear. Some in-situ diffraction experiments [8] indicated a pressure induced amorphization at 25 GPa, however, the energydispersive x-ray diffraction technique used in that study can be misleading if large crystallites with preferred orientation form. Indeed, a phase with large crystallites has been reported above 25 GPa in angle-dispersive x-ray diffraction study on S but without structural determination [3]. The most recent in situ study on the low-pressure phase diagram of sulfur [9,10] provided the first high-quality diffraction data on high-pressure sulfur. This study showed a transformation of the ambient-pressure S8 ring molecule of the orthorhombic Fddd phase S-I to a new phase S-II, consisting of chains with trigonal geometry. Phase S-II is reported to form only on heating of S-I (because of a kinetic barrier) at pressures above 1.5 GPa. This study [9,10], however, was restricted to pressures of 5 GPa, leaving the high-pressure behavior of S-II unknown. Thus, the crystal structure of sulfur in the pressure range between 5 and 86 GPa still remains unknown. In order to understand the high-pressure behavior of sulfur, we have conducted several angle-dispersive x-ray diffraction experiments using diamond anvil cells and monochromatic high-energy high-brilliance synchrotron radiation over a broad P-T range.