Abstract:We present an experimental study on the drag reduction by polymers in Taylor-Couette turbulence at Reynolds numbers ($Re$) ranging from $4\times 10^3$ to $2.5\times 10^4$. In this $Re$ regime, the Taylor vortex is present and accounts for more than 50\% of the total angular velocity flux. Polyacrylamide polymers with two different average molecular weights are used. It is found that the drag reduction rate increases with polymer concentration and approaches the maximum drag reduction (MDR) limit. At MDR, the friction factor follows the $-0.58$ scaling, i.e., $C_f \sim Re^{-0.58}$, similar to channel/pipe flows. However, the drag reduction rate is about $20\%$ at MDR, which is much lower than that in channel/pipe flows at comparable $Re$. We also find that the Reynolds shear stress does not vanish and the slope of the mean azimuthal velocity profile in the logarithmic layer remains unchanged at MDR. These behaviours are reminiscent of the low drag reduction regime reported in channel flow (Warholic et al., Exp. Fluids, vol. 27, issue 5, 1999, p. 461-472). We reveal that the lower drag reduction rate originates from the fact that polymers strongly suppress the turbulent flow while only slightly weaken the mean Taylor vortex. We further show that polymers steady the velocity boundary layer and suppress the small-scale Görtler vortices in the near-wall region. The former effect reduces the emission rate of both intense fast and slow plumes detached from the boundary layer, resulting in less flux transport from the inner cylinder to the outer one and reduces energy input into the bulk turbulent flow. Our results suggest that in turbulent flows, where secondary flow structures are statistically persistent and dominate the global transport properties of the system, the drag reduction efficiency of polymer additives is significantly diminished.

Modification of the Turbulent Energy Cascade by Polymer Additives

Effects of Polymer Additive on Turbulent Bulk Flow: The Polymer Concentration Dependence

Abstract Submitted for the DFD11 Meeting of The American Physical Society Concentration dependence of the effects of polymer additives on bulk turbulence1

Turbulence of Dilute Polymer Solution

Bulk Turbulence in Dilute Polymer Solutions

Effect of Polymeric Additives on Turbulent Flow in Opposed Jets

Turbulent duct flow with polymers

Fluid acceleration in the bulk of turbulent dilute polymer solutions

Coherent structure dynamics and identification during the multistage transitions of polymeric turbulent channel flow

Less is more: modelling polymers in turbulent flows

Polymer additives reduce fluid drag in turbulent flow

Polymers in Swarming Bacterial Turbulence

Effects of polymer additives on Rayleigh-Taylor turbulence

The interplay of inertia and elasticity in polymeric flows

Global drag reduction and local flow statistics in Taylor-Couette turbulence with dilute polymer additives

Effect of polymer additives on dynamics of water level in an open channel

Experimental research on drag reduction by polymer additives in a turbulent pipe flow

Early turbulence in viscoelastic flow past a periodic cylinder array

Experimental observation of the elastic range scaling in turbulent flow with polymer additives

Extending Kolmogorov Theory to Polymeric Turbulence

Effects of polymers on the cavitating flow around a cylinder: A large-scale molecular dynamics analysis