Infrared Drying Properties and Drying Experiment of Carbon Fiber for Agricultural Production
Zhang Weipeng,Xiao Hongwei,Gao Zhenjiang,Zheng Zhian,Ju Haoyu,Liang Shan,Zheng Xia
DOI: https://doi.org/10.11975/j.issn.1002-6819.2015.19.039
2015-01-01
Abstract:Recently, infrared radiation heating has been widely applied in different thermal processing systems in food industry. It has several advantages such as high efficiency, low energy consumption, and high quality of dried products. In addition, the heating power generated from infrared radiation can penetrate into food materials. But the electric radiant infrared heater, such as ceramic infrared heater and gas-fired infrared radiator, has the some drawbacks e.g., large structure and high heating temperature, which lead to higher energy consumption of infrared drier. In order to explore the drying characteristics of carbon fiber and develop a new heating technology of infrared drying, the drying characteristics of banana slices, apple slices, carrot slices and agaric were investigated in a carbon fiber infrared heating. The material internal temperature, ambient temperature, ambient humidity of drying process were detected during drying process. Result indicated that: 1) Far-infrared waves in the rage of 1-30μm could be launched by the carbon fiber heating board, and main infrared waves were concentrated in the rage of 5-15μm. The surface temperature of carbon fiber board was in the range of 84-92℃. Fruits and vegetables could be quickly dried in this form of infrared drying. Under the radiation power of 1.1 kW/m2 and the radiation distance of 8 mm, the drying time of 3 kinds of fruit slices (20 mm×20 mm×11 mm) and agaric (approximately 6-8 g) was about 270-300 min; 2) Carrot slices with size of 20 mm×20 mm and 5-11 mm thickness were dried under the radiation power of 1.1 kW/m2. It was found that the internal temperature increased with the increase of the thickness. 3) Under the radiation power of 1.1 kW/m2, at the radiation distance of 4, 8 and 12 mm, the drying time of 11 mm thick carrot slices was 240, 320 and 450 min, respectively and the drying time increased with the increase of the radiation distance. The adjustment of the distance between the heat source and the material could enhance convection heat transfer, and the temperature of the medium inside the dryer could also be effective in decreasing the drying time without causing quality degradation. 4) Samples were dried in 5 modes: infrared drying, infrared + dehumidification drying, infrared + cold air drying, infrared + hot air drying, hot air drying. The energy consumption of infrared drying of the carbon crystal fiber infrared plate was lower, and the energy consumption of the infrared + cold air drying mode was only 7.68% of the traditional hot air drying at temperature of 55℃.“Infrared+ hot air” drying could effectively shorten the drying time and reduce the energy consumption, which were 60% and 49.39% of the hot air drying at 55℃, respectively. In addition, reducing the humidity of drying chamber at the initial drying stage and keeping low air velocity could accelerate drying process. This phenomenon was probably due to the fact that with air velocity increasing, the cooling effect is enhanced, which can reduce the material’s temperature. In summary, the carbon crystal fiber infrared plate can be used in fruits and vegetables drying as the heating source, which has the advantages of higher heating rate, compact radiation distance, lower energy consumption and simple structure. The findings of the current work provide theoretical basis for the practical application of carbon fiber heating infrared plate in drying.