Control Preparation and Chracterisation of Inorganic Nanocrystals As Long-Term Micronutrient Foliar Fertilisers
Peng Li
2013-01-01
Abstract:The micronutrient deficiency, particularly the deficiency of metal elements, such as zinc, copper, manganese, and iron, both in soils and plants is a global issue that limits the crop production yield and moreover threatens the public health of human beings. The most cost-effective way for the element deficiency correction is to apply the foliar fertiliser made of the elements. In this thesis, the control preparation and characterisation of synthetic nanocrystals as potential suspension foliar fertilisers for supplementing these four metal elements with a long-term effect have been investigated. As summarised in the literature review, the present soluble fertilisers may cause phytotoxicity whereas the insoluble ones are not efficient, thus we have suggested the suitable ion concentration release from the crystal suspensions is 20-100, 2-8, 10-200, and 20-100 mg/L for zinc, copper, manganese, and iron, respectively. Therefore several inorganic nanocrystals with limited solubility have been rationally selected for extensive investigation. Other desired properties include nanoscale morphology, good shelf life, and consistent preparation via precipitation. Since preparation parameters, including the initial reactant ratio, temperature, ageing time, and initial concentrations, influence the crystal phase, composition and morphology, their effects on the physicochemical properties of as-selected compounds have been extensively examined and discussed.In the case of zinc, phase transformation and morphology variation along the change of preparation conditions during the control preparation of zinc hydroxide nitrate nanocrystals have been examined. Tests of aqueous stability and zinc ion release have indicated that control-prepared two-dimensional zinc hydroxide nitrate nanosheets are slightly dissolved in the practical aqueous environment (pH = 6.5), leading to ~37 mg/L zinc ions released in the aqueous phase, which is sufficient for correcting zinc deficiency.Similar in the structure, composition and morphology of zinc hydroxide nitrate product, three kinds of copper compounds have been selected and further prepared under the similar conditions. Pure copper hydroxide nitrate has released too many Cu2+ ions (10 mg/L) to be a suitable foliar fertiliser. The mixed hydroxide nitrates of copper and zinc has been found to be more suitable (4 mg/L Cu2+). Cu-Zn hydroxide sulphate has release much less Cu2+ ions (1 mg/L), therefore could only be suitable for correction of slight Cu deficiency. Their aqueous stabilities are all similar to zinc hydroxide nitrate as they share the layered structure of basic salts.All three selected manganese compounds have the desired two-dimensional nanosheet morphology. Manganese oxalate can release ~110 mg/L Mn2+ ions, and manganese ammonium phosphate ~10 mg/L Mn2+ ions, so these two foliar fertilisers could be suitable for the correction of severe and slight Mn deficiency, respectively. Hureaulite has the mostdesirable morphology and particle size, but its dissolved Mn2+ concentration is too low (~1 mg/L) to be adopted.For Fe2+, ferrous ammonium phosphate and ferrous oxalate have been extensively investigated. Partial oxidation occurs during the preparation of ferrous ammonium phosphate since ferric oxide is observed, whereas the oxalate chelate has good protection on Fe(II) from oxidation. The particle sizes of both synthetic compounds are both microscale, which need reduction for strong adhesion on the foliar surface. The Fe2+ concentration released from synthetic ferrous ammonium phosphate and ferrous oxalate are ~9 and ~33 mg/L, respectively, which are suitable for the correction of slight and severe Fe deficiency.In summary, several potential foliar fertilisers have been identified and could be used for corrections of the global micronutrient deficiency based on the requirements for the efficient fertilisers that have been proposed in this thesis.