Abstract:Wireless networks are built upon a shared medium that makes it easy for adversaries to launch jamming-style attacks. These attacks can be easily accomplished by an adversary emitting radio frequency signals that do not follow an underlying MAC protocol. Jamming attacks can severely interfere with the normal operation of wireless networks and, consequently, mechanisms are needed that can cope with jamming attacks. In this paper, we examine radio interference attacks from both sides of the issue: first, we study the problem of conducting radio interference attacks on wireless networks, and second we examine the critical issue of diagnosing the presence of jamming attacks. Specifically, we propose four different jamming attack models that can be used by an adversary to disable the operation of a wireless network, and evaluate their effectiveness in terms of how each method affects the ability of a wireless node to send and receive packets. We then discuss different measurements that serve as the basis for detecting a jamming attack, and explore scenarios where each measurement by itself is not enough to reliably classify the presence of a jamming attack. In particular, we observe that signal strength and carrier sensing time are unable to conclusively detect the presence of a jammer. Further, we observe that although by using packet delivery ratio we may differentiate between congested and jammed scenarios, we are nonetheless unable to conclude whether poor link utility is due to jamming or the mobility of nodes. The fact that no single measurement is sufficient for reliably classifying the presence of a jammer is an important observation, and necessitates the development of enhanced detection schemes that can remove ambiguity when detecting a jammer. To address this need, we propose two enhanced detection protocols that employ consistency checking. The first scheme employs signal strength measurements as a reactive consistency check for poor packet delivery ratios, while the second scheme employs location information to serve as the consistency check. Throughout our discussions, we examine the feasibility and effectiveness of jamming attacks and detection schemes using the MICA2 Mote platform.

Feasibility Assessment of Repeater Jamming Technique for DSSS

Evaluation of Security for DSSS under Repeater Jamming.

Performance of DSSS against Repeater Jamming.

The Feasibility of Launching and Detecting Jamming Attacks in Wireless Networks.

Analytical Technique Leveraging Processing Gain for Evaluating the Anti-Jamming Potential of Underwater Acoustic Direct Sequence Spread Spectrum Communication Systems

A New Electronic Jamming Method Inspried from Bionics System

Dynamic Spectrum Anti-Jamming Communications: Challenges and Opportunities

A Novel Interference Suppression Method for Interrupted Sampling Repeater Jamming Based on Singular Spectrum Entropy Function

Characteristics Analysis of Interrupted-Sampling Repeater Jamming

Passive DSSS: Empowering the Downlink Communication for Backscatter Systems

DRFM-Based Repeater Jamming Reconstruction and Cancellation Method with Accurate Edge Detection

Self-Controlled Jamming Resilient Design Using Physical Layer Secret Keys

Interrupted-sampling multi-strategy forwarding jamming with amplitude constraints based on simultaneous transmission and reception technology

Jam resistance performance of UWB BPM impulse radio with time hopping vs. direct sequence

Repeater Jamming Against LFM Pulse Radar

Anti-Jamming Precoding Against Disco Intelligent Reflecting Surfaces Based Fully-Passive Jamming Attacks

A Barrage Noise Jamming Method Based on Double Jammers Against Three Channel SAR GMTI

Interrupted Sampling Repeater Jamming Recognition and Suppression Method Based on DBSCAN Algorithm

ISRJ Suppression Algorithm Based on Wavelet Transform and Compressed Sensing Reconstruction