Abstract:The dual-side inductor–capacitor–capacitor (LCC) topology circuit has been widely adopted in wireless power transfer (WPT) systems due to its constant output current characteristic. However, most conventional control methods need specific synchronization techniques between the primary and secondary sides to avoid the oscillation in the system, which increases the cost and control complexity. To solve this issue, this article proposes a new duty cycle control (DCC) strategy for a dual-side LCC resonant converter with a semibridgeless active rectifier (SAR). With such a control strategy, gate signals of the primary- and secondary-side circuits do not need to be synchronized, which could reduce the complexity and the cost of the WPT system. Besides, the switching frequency of the secondary side can be decreased significantly. This article first presents the modal analysis of phase shift control (PSC) and DCC. Then, generalized state-space averaging (GSSA) modeling with PSC and the hybrid average modeling with DCC are performed. In addition, controllers’ design for both strategies is conducted to achieve the constant output voltage. Finally, the eigenvalues’ analysis is used to determine the stability region of the WPT system. The theoretical analysis has been validated by both simulation and experimental results.

Dual-Side Closed-Loop Control, Stability Analysis, and Parameter Design of Two-Stage LCC-LCC WPT

Double Closed Loop Controller with Current Sharing of Interleaved DC/DC Converter for Dynamic Wireless Power Transfer System

A Control Design Based on Eqivalent Circuit Model for Wireless Power Transmission System

Feedback Linearization Control for the Receiving-Side Buck Converter of Dynamic Wireless Charging System of Electric Vehicles

Coordinated Design of UPFC-a Variable-parameter Open-loop Decoupling Method

A Closed-Loop Control Strategy of Maximum Efficiency Point Tracking for Wireless Power Charging System

Design and Simulation of a PFM-PWM Hybrid Controller for DCDC Converter with CLLC Topology

Modelling, Analysis and Control Design of A Two-Stage Photovoltaic Generation System

Transient Stability Analysis and Control Design of Droop-Controlled Voltage Source Converters Considering Current Limitation.

Stabilization Of Dc-Dc Buck Power Converter Feeding A Mixed Load Using Passivity-Based Control With Nonlinear Disturbance Observer

Duty Cycle Control Strategy for Dual-Side LCC Resonant Converter in Wireless Power Transfer Systems

Identification and Control of LCC-S WPT Systems Using a Linear Parameter Varying Model

Control Strategy of Cascaded Multilevel Converter Based on Dual Active Bridge for Wind Energy Conversion System.

Impedance Characteristic Analysis and Phase-locked Angle Feedforward-based Stability Improvement for LCC-HVDC in Sending AC Grid

A Design Method for Large-Coupling-Range Series-Series Compensated WPT Systems under Practical Constraints

A Dual-Sided Control Strategy Based on Mode Switching for Efficiency Optimization in Wireless Power Transfer System

Analysis and Design of a ZVS Boost/buck-Boost Dual Mode PFC Converter with Universal Input and Wide Output Voltages

Design and Analysis of Multiloop Controllers with DC Suppression Loop for Paralleled UPS Inverter System

Closed-Loop Control Design For Wpt System Using Power And Data Frequency Division Multiplexing Technique

Dynamic Modeling and Control Design Based on Singular Perturbation Theory for High-Order Wireless Power Transfer System

Two-stage isolated AC/DC converter and its compound control strategy