Comparison of Receiver Front-end Differences for RF Fingerprint Based IoT Device Identification

Hua Fu,Xiaoyu Zhang,Linning Peng
DOI: https://doi.org/10.1109/icsip57908.2023.10271025
2023-01-01
Abstract:RF fingerprint (RFF) based wireless device identification is an emerging technique for authentication. In this paper, we investigate RFF based Zigbee device identification with different front-end receivers. 12 CC2530 Zigbee transmitters are employed as identification targets. The USRP and HackRF software defined radio (SDR) platforms are used as high-end and low-end receivers. Zigbee device identification is evaluated from practical measurements and crossing test. Experimental results show that it is essential to obtain the target training features with high-end USRP receiver. Moreover, it is also practical to identify accessing device with low-end HackRF receiver using the trained features from high-end USRP receiver. Finally, experimental results show that both USRP and HackRF receivers could obtain 0 identification error rate in near field line-of-sight (LOS) condition. However, in the case of remote non-line-of-sight (NLOS), low-end HackRF receiver with 8-bits analog to digital convertor (ADC) suffers from serious signal to noise ratio (SNR) degradation compared to high-end USRP receiver.
What problem does this paper attempt to address?