Abstract:Insulation failure usually occurs in AC gas-insulated transmission (AC GIL) in field operation, in which the primary cause is the charged motion of metal particles in the electric filed. At present, the particle inhibition method applied is to design particle traps on the inner wall of the GIL shell. However, due to the large randomness of the charged motion for metallic particles and the limitations of field test methods, a particle trap has not yet been designed from the perspective of particle trapping effectiveness. In this paper, firstly, referring to the size of a running 252 kV AC GIL, a 1:1 scaled 3-D similarity simulation model is established to obtain the dynamic characteristics of particles with different sizes under the operating voltage level. This model can form symmetry between the real equipment, and its simulated simulation trajectory can achieve symmetry with the actual one. Secondly, an experimental platform that can easily capture the motion of the particles is set up to experimentally verify the symmetry between the field operating equipment and the simulation model. Finally, the particle traps are set on both sides of the concave and convex surface of the basin insulator, and an optimization scheme for the design of the particle trap is proposed from three aspects: the electric field regulation of the trap, the captured probability of particles, and the trap location. The proposed research shows that, with respect to the motion characteristics of the particles, this paper selects circular hole-shaped trap and its thickness, slot spacing, and slot width are 10 mm, 6 mm, and 8 mm, respectively. When the traps are arranged, one at the bottom of the shell at 70 mm and 80 mm from each side of the concave and convex insulator, the capture probability of the traps on both sides can be as high as 78% and 70%, respectively. Therefore, the analysis and optimization method in this paper has important reference value according to similarity concepts for optimizing particle traps in AC GIL at a certain voltage level.

Analysis and Design of Particle Trap in Transmission Line for the CRAFT NNBI System

Analysis and Design of Post Insulator of Transmission Line Towards the CRAFT NNBI Test-Bed

Research on the Dynamic Capture by Particle Trap in 1100 kV Gas Insulated Transmission Line for Metal Particles

Study on Designing Optimization of Particle Trap in DC GIL

Particle behavior and trap design for ±320 kV gas-insulated power transmission line (GIL)

Conceptual design of 5 MW-NBI injector for HL-2 M tokamak

Effect of Particle Trap on Motion Characteristics of Metal Particles in AC GILs and Parameter Optimization

Trap Parameters Optimization Based on Metal Particle Dynamic Simulation Method

Efficiency Analysis of Particle Trapping for ±320 Kv GIL

Physics and engineering design of 400 keV H- accelerator for negative ion based neutral beam injection system in China

Insulation design of -800 kV gas insulation transmission line for negative ion based neutral beam injector

Structure design and analysis of RF ion source for negative ion source test facility

Suppression of stray electrons in the negative ion accelerator of CRAFT NNBI test facility

Influence of cusp magnetic field configuration on plasma parameters of radio frequency driven negative ion source for CRAFT NNBI

Design of acceleration grid power supply for CFETR negative-ion-based neutral beam injection prototype

Experimental and Simulation Study on the Backstreaming Positive Ions on the Quarter-Size Negative Ion Source for CRAFT NNBI Test Facility

The Negative Beam Source with Single Driver for CRAFT NNBI: Design and Conditioning Results

Study on stray electrons ejecting from a long-pulse negative ion source for fusion

Design on High Voltage Generation and Surge Suppression of AGPS for CFETR N-NBI Prototype

Study on Capture Efficiency of Particle Trap and Performance Improvement Method for DC GIL/GIS

Conceptual design of a beam source for negative neutral beam injector of CRAFT facility