Abstract:Near-field high-resolution synthetic aperture radar (SAR) imaging is mostly accompanied by a large number of data acquisition processes, which increases the system complexity and device cost. According to extensive reports, reducing the number of sampling points of a radar in space can greatly reduce the amount of data. However, when spatial sparse sampling is carried out, a ghost normally appears in the imaging results due to the high side lobes generated in the azimuth. To address this issue, a technique is introduced in this paper to recover the blank data through amplitude and phase compensation based on the correlation between sparse array sampling through adjacent points. Firstly, the data sampled by the sparse array is compressed in the range direction to obtain the expected data slices in the same range direction. Then, the blank element of the slice is compensated for with amplitude and phase to obtain full aperture data. Finally, the matched filter method is used to aid in the image reconstruction. The simulation results verified that the method proposed in this paper can effectively reconstruct the image under two kinds of sparse sampling conditions. Thus, a simple single-input single-output (SISO) synthetic aperture radar imaging test bench is established. Compared with the results of a 1 mm (1/4 λ) sampling interval, the quality of the reconstructed image under the condition of a 4 mm (1 λ) sampling interval still stands using our proposed method. Demonstrated by the experiment, the normalized root-mean-square error(NMSE) is 5.75%. Additionally, when the spatial sampling points are sampled randomly with 30% of the full sampling condition, this method can also restore and reconstruct the image with high quality. Due to the decrease of sampling points, the data volume can be reduced, which is beneficial for improving the scanning speed and alleviating the pressure of data transmission for near-field high resolution SAR imaging systems.

Improving 3D Reconstruction with Airborne Array-InSAR Images Using a Capon-Based Sidelobe Reduction

A New SAR Imaging Method for Sparse Field Traget

Coprime Sensing for Airborne Array Interferometric SAR Tomography

Spatially Variant Sidelobe Suppression for Linear Array MIMO SAR 3-D Imaging

A Range-Elevation Combined SAR Tomography for Sparse Airborne Array-InSAR Images

Sidelobe Suppression with Resolution Maintenance for SAR Images Via Sparse Representation

Geometric Continuity Constrained SAR Tomography for Sparse Array-InSAR Acquisitions

Airborne Circular Flight Array SAR 3D Imaging Algorithm of Buildings Based on Layered Phase Compensation in the Wavenumber Domain

Near-Field High-Resolution SAR Imaging with Sparse Sampling Interval

Error Analysis and 3D Reconstruction Using Airborne Array InSAR Images

An Algorithm for Airborne SAR Tomography 3D Imaging

Linear Array Sar Imaging Via Compressed Sensing

Sparse array SAR 3-D imaging using compressed sensing

Three-Dimensional High-Resolution Space-Borne ISAR Imaging With Compact Antenna Configuration for Large Rotational Angle

On the Value of 3D Reconstruction in Urban Areas Using Three Channel Airborne Array-INSAR Images

Azimuth Spectrum Reconstruction Algorithm Based on Updating Factors Regionally for Onboard Real-Time Multichannel SAR Imaging

Three-Dimensional Reconstruction of Partially Coherent Scatterers Using Iterative Sub-Network Generation Method

3D Sparse SAR Image Reconstruction Based on Cauchy Penalty and Convex Optimization

Quality Improvement Synthetic Aperture Radar (SAR) Images Using Compressive Sensing (CS) With Moore-Penrose Inverse (MPI) and Prior From Spatial Variant Apodization (SVA)

Three-Dimensional Structural Parameter Inversion of Buildings by Distributed Compressive Sensing-Based Polarimetric SAR Tomography Using a Small Number of Baselines

Robust Blind Scatterer Separation In Multibaseline Insar