Abstract:Background Biplanar X-ray system providing anteroposterior and sagittal plane with an ultra-low radiation dose and in weight-bearing position is increasingly used for spine imaging. The original three-dimensional (3D) reconstruction method from biplanar X-rays has been widely used for clinical parameters, however, the main issue is that manual adjustments of the 3D model was quite time-consuming and limited to thoracolumbar spine. A quasi-automated 3D reconstruction method of the spine from cervical vertebra to pelvis was proposed, which proved fast and accurate in 57 patients with adolescent idiopathic scoliosis. The aim of this study was to compare the newly developed technique of quasi-automatic 3D measurement with classical 2D measurements in a large cohort. Methods A total of 494 adults with biplanar EOS X-ray scanning were included in this study and divided into health and deformity group according to the presence of spinal deformity. The proposed method of quasi-automatic 3D measurement was applied to all these subjects. The radiographic parameters included: thoracic kyphosis (TK), lumbar lordosis (LL), pelvic incidence (PI), pelvic tilt (PT), sagittal vertical axis (SVA), T1 pelvic angle (TPA) in sagittal plane, and cobb angle in coronal plane. Comparison was made between quasi-automatic and manual measurement. Results The mean age was 53.7±19.9 years old. In the whole population, the mean differences between the two methods were 3.9° for TK (30.5°±9.9° vs. 26.5°±9.3°, P<0.001), -5.2° for LL (-47.5°±11.2° vs. -42.4°±11.0°, P<0.001), 3.6° for PI (46.9°±10.3° vs. 43.9°±10.3°, P<0.001), -0.2° for PT (11.9°±7.7° vs. 12.0°±8.2°, P=0.328), -2.1 mm for SVA (15.7±26.2 vs. 17.8±26.3 mm, P=0.221) and -1.1° for TPA (9.0°±7.6° vs. 10.1°±7.8°, P=0.051). The deformity group had similar mean differences with the asymptomatic group with the values ranged from -4.1° to 3.8° for sagittal parameters. The mean differences of Cobb angle were 1.9° for patients with Cobb angle <30° and 2.3° for patients with Cobb angle >30°, respectively. Correlation analysis showed r2 for all clinical parameters ranged from 0.667 to 0.923. On average, the new method takes 5 minutes to compute all the parameters for one case. Conclusions In conclusion, this ergonomic and efficient quasi-automatic method for full spine proved fast and accurate measurement in a large population, which showed great potential in extensive clinical application.

A Novel Measurement Method for Human's Spinal Morphology

The Measurement of Cobb Angle Based on Spine X-ray Images Using Multi-Scale Convolutional Neural Network.

3D Construction of the Human Spine Cervical Segment and Statistical Analysis of Scientific Measurement

[Three-dimensional spine morphology measuring technology for daily surface monitoring]

Back Shape Measurement and Three-Dimensional Reconstruction of Spinal Shape Using One Kinect Sensor

Reconstruction of a Human Spine Curve in the Sagittal Plane From the Measured Contour of the Human Back

Dimensional Coordinate Measurements: Application In Characterizing Cervical Spine Motion

Automatic Angle of Trunk Rotation Detection Using 3D Sensor Imaging in Scoliosis Assessment

A Neural Network Approach for Inertial Measurement Unit-Based Estimation of Three-Dimensional Spinal Curvature

Determination of the 3D Human Spine Posture from Wearable Inertial Sensors and a Multibody Model of the Spine

Reproducibility and Reliability of a New Ultrasonography-Based System for Measuring Scoliosis

Anatomical prior based vertebra modelling for reappearance of human spines

The Comparison of Convolutional Neural Networks and the Manual Measurement of Cobb Angle in Adolescent Idiopathic Scoliosis

Comparison of 3D and 2D Characterization of Spinal Geometry from Biplanar X-rays: a Large Cohort Study.

A Photogrammetric Method for the Measurement of Three-Dimensional Cervical Range of Motion

Computer-Aided Cobb Measurement Based on Automatic Detection of Vertebral Slopes Using Deep Neural Network

Development of Automatic Assessment Framework for Spine Deformity Using Freehand 3-D Ultrasound Imaging System

3D Vertebrae Measurements: Assessing Vertebral Dimensions in Human Spine Mesh Models Using Local Anatomical Vertebral Axes

Correlative Assessment of Machine Learning-Based Cobb Angle Measurements and Human-Based Measurements in Adolescent Idiopathic and Congenital Scoliosis

Automatic Vertebral Rotation Angle Measurement of 3D Vertebrae Based on an Improved Transformer Network

Assessing Validation of Dual Fluoroscopic Image Matching Method for Measurement of in Vivo Spine Kinematics