Abstract:This paper presents a comparison between two design methodologies applied to permanent magnet synchronous machines for hybrid and electric vehicles (HEVs and EVs). Both methodologies are based on 2D finite element models and coupled to a genetic algorithm to optimize complex non-linear geometries such as multi-layer permanent magnet machines. To reduce the computation duration to evaluate Induced Voltage and Iron Losses for a given electrical machine configuration, a new methodology based on geometrical symmetries and magnetic symmetries are used and is detailed. Two electromagnetic models have been developed and used in the design stage. The first model was the stepped rotor position finite element analysis called abc model which considered the spatial harmonics without any approximation of the waveform of flux linkage inside the stator, and the second model was based on a fixed rotor position called dq model, with the approximation that the waveform of flux linkage inside the stator was sinuous. These two methodologies are applied to the design of a synchronous machine for HEVs and EVs applications. Design results and performances are analyzed, and the advantages and drawbacks of each methodology are presented. It was found that the dq model is at least 5 times faster than the abc model with high precision for both the torque and induce voltage evaluation in most cases. However, it is not the case for the iron losses computation. The iron loss model based on dq model is less accurate than the abc model with a relative deviation from the abc model greater than 70% at high control angle. The choice of the electromagnetic model during the optimization process will therefore influence the geometry and the performances of the obtained electrical machine after the optimization.

Automatic Design System With Generative Adversarial Network and Vision Transformer for Efficiency Optimization of Interior Permanent Magnet Synchronous Motor

Electromagnetic Performance Analysis and Optimization of Asynchronous Motors Based on Finite Element Analysis

Hybrid Analytical Model for Predicting the Electromagnetic Losses in Surface-Mounted Permanent-Magnet Motors

Design Optimization with Outer Rotor Interior Permanent Magnet Synchronous Motor with Hybird Permanent Magnet

Nonlinear Analytical Model-Embedded Optimal Design for ER-PMSM

Fast Evaluation of Driving Cycle Efficiency of Interior Permanent Magnet Synchronous Machines for Electric Vehicles Considering Step-Skewing

Dynamic Reluctance Mesh Modeling and Losses Evaluation of Permanent Magnet Traction Motor

Rapid Calculation and Optimization of Vibration and Noise of Permanent-Magnet Synchronous Motors for EVs Based on Equivalent Structural Network

Efficient Design and Torque Prediction for Similar PMaSynRMs with a Generalized Attention Convolutional Network

Multi-Objective Optimal Design of High-Speed Surface-Mounted Permanent Magnet Synchronous Motor for Magnetically Levitated Flywheel Energy Storage System

Investigation of Analytical Models for Surface-Mounted Permanent Magnet Motor Using Voltage Source Inverter

Multi-Objective Design of an Interior Permanent Magnet Machine with Robustness Considerations

Design of a 35 kW Permanent Magnet Synchronous Motor for Electric Vehicle Equipped With Non-Uniform Air Gap Rotor

Modeling of iron losses of permanent-magnet synchronous motors

Kriging Surrogate Model-Based Design of an Ultra-High-Speed Surface-Mounted Permanent-Magnet Synchronous Motor Considering Stator Iron Loss and Rotor Eddy Current Loss

Design Optimization of Multi-Layer Permanent Magnet Synchronous Machines for Electric Vehicle Applications

Modular Dynamic Equivalent Magnetic Network Modeling of YASA Type Axial Flux Permanent Magnet Motor

The Efficiency Optimization of Permanent Magnet Synchronous Machine DTC for Electric Vehicles Applications Based on Loss Model

An efficient multidisciplinary design research for the integrated low speed permanent magnet motor system based on analytical and numerical hybrid analysis

Fast Magnetic Field Prediction Based on Hybrid Subdomain Method and Multiobjective Optimization Design for Interior Permanent Magnet Synchronous Machines

The influence of optimizing rotor on the performance and the iron loss of the permanent machine