Abstract:By chosing PolyMaxTM PLA as the sample material, thin-walled tube structures with arc-shaped origami patterns were prepared by a three-dimensional printing technology. Based on quasi-static axial compression experiments, their axial quasi-static crushing and impact compression deformation modes and energy absorption were simulated by using the ABAQUS software to investigate the influences of the prefolding angle and the number of in-plane arrays on the crushing mode and energy absorption of the structures. The results by the finite element calculation are in agreement with the experimental ones. The deformation of the tubes can be divided into four stages including initial crushing stage, prefolding-angle plastic rotation stage, web plastic buckling stage, and complete crushing and densification stage. The arc-shaped corrugations demonstrate some obvious advantages at reducing the initial peak force and the fluctuation range of the impact force. The square tube was compared with the arc-shaped origami patterns with the same height and approximately the same mass. For the single-cell models, the specific energy absorption of the model with only 70° crease inclination is higher than that of the square tube under the quasi-static crushing. For the multiple-array tube structures, the specific energy absorption of the single-cell square tube is higher than those of the arc-shaped tubes. When considering the crush force efficiency and specific total efficiency, the arc-shaped tubes have an advantage over the square tubes, the model with a crease inclination of 50° is the best. Under the impact crushing loading condition, the specific energy absorptions of the multiple-array tubes are higher than those of the arc-shaped tubes. The crush force efficiency and specific total efficiency of the arc-shaped tubes are higher than those of the square tubes under the impact velocity of 10 m/s, the model with a crease inclination of 50° is the highest. The crush force efficiency and specific total efficiency of the model with only 50° crease inclination are higher than those of the square tube under the impact velocity of 20 m/s.

Rigidity Analysis and Mechanical Properties of Programmable Origami Tubes

In Situ Stiffness Manipulation Using Elegant Curved Origami

Novel open-section origami tubes with multiple programmable mechanical properties

Compressive Characteristics of Interleaved Origami Tube Metamaterials Based on the "Flip-Flop" Fold Pattern

Study of Collapsed Deformation and Energy Absorption of Polymeric Origami-Based Tubes with Viscoelasticity

Geometrically Graded Origami Tubes

A strategy to improve buckling resistance of a Miura origami-based tube

Imperfection Insensitivity of Origami-Inspired Tubular Structures

Rigid Folding of Generalized Waterbomb Origami Tubes

Arranging the Plastic Hinges and Improving the Strength of Steel Tubes with Tapered Ends: Analysis and Tests

Unified Parametric Modeling of Origami-Based Tube

Programming Morphological and Mechanical Performance of Cyclic Ori-Kirigami Via Design-Feasible Parameter Space

Energy Absorption of Origami Tubes with Polygonal Cross-Sections

Compression Deformation and Energy Absorption of Thin-Walled Structures with Arc-Shaped Origami Patterns

Out-of-plane Compressive Mechanical Properties of Square-Twist Origami Folded-Stable State

RIGID FOLDABILITY OF TRIANGLE-TWIST ORIGAMI PATTERN AND ITS DERIVED 6R LINKAGE

Explosive rigidity percolation in origami

FOLDING OF A TYPE OF DEPLOYABLE ORIGAMI STRUCTURES

Rigid-foldable Spiral Origami with Compression-Torsion Coupled Motion Mode

Rigid-foldable cylindrical origami with tunable mechanical behaviors

An Extended Family of Rigidly Foldable Origami Tubes