Abstract:In this study, three different configurations of absorption cycles are compared and analyzed from exergetic and exergoeconomic points of view. These configurations include the simple absorption cycle, the combined ejector-absorption cycle, and the combined compression–absorption cycle, as well as a flat plate solar collector and a storage tank. Ammonia sodium thiocyanate is used as the working solution. In both combined cycles, the absorber operates at intermediate pressure, allowing three pressure levels to be considered. The simulations are performed using EES software. According to the base case results, in all three cycles studied, the solar collector should be taken into account more than other components in terms of exergy and exergoeconomic, because it has the highest amount of exergy destruction, the highest exergy destruction cost rate and the highest cost rate. The results of the systems parametric analysis show that as the pressure ratio of the ejector and compressor increases, the solar collector area and the heat rate of the generator decrease. Furthermore, by increasing the pressure ratio of the ejector and compressor, the economic factors are reduced, thus improving the exergoeconomic performance of the combined cycle compared to the simple absorption cycle. It is also observed that for the same pressure ratio of ejector and compressor, the exergy efficiency of the ejector cycle is slightly higher than that of the compression cycle. On evaluation of the results, the effect of the generator temperature on this improvement is clearly evident. Finally, on the basis of the results, since the highest pressure ratios can be obtained in the combined solar compression–absorption cycle, this configuration has the best performance among the three cycles studied from an exergetic and exergoeconomic point of view, except for the exergy efficiency, which increases in the combined solar ejector-absorption cycle. Exergetic operating parameters, such as coefficient of performance, solar coefficient of performance and solar exergetic efficiency, are higher in the compression–absorption cycle than in the ejector-absorption cycle. The compression–absorption cycle shows a significant reduction in exergoeconomic factors, such as the total investment cost rate, the total cost rate of exergy destruction, the total cost rate and the unit cost of cooling production, indicating that the use of the compressor in the absorption refrigeration cycle leads to a better performance compared to the use of an ejector.

Comparison Between Two LiBr–H2O Absorption-Compression Chillers and a Simple Absorption Chiller Driven by Various Solar Collectors: Exergy-economic Performance and Optimization

Comparison of CPC Driven Solar Absorption Cooling Systems with Single, Double and Variable Effect Absorption Chillers

Experimental Performance Investigation of Small Solar Air-Conditioning Systems with Different Kinds of Collectors and Chillers

Comparisons and optimization of two absorption chiller types by considering heat transfer area, exergy and economy as single-objective functions

Comparison of Absorption Refrigeration Cycles for Efficient Air-Cooled Solar Cooling

Investigation on a Hybrid Single/double Effect Solar Absorption Cooling System Driven by Fresnel Solar Collector with Thermal Storage.

Thermodynamic and Economic Performance Assessment of Double-Effect Absorption Chiller Systems with Series and Parallel Connections

Comparative Study on Two Low-Grade Heat Driven Absorption-Compression Refrigeration Cycles Based on Energy, Exergy, Economic and Environmental (4E) Analyses

Experimental and Analytical Study on an Air-Cooled Single Effect Libr-H2o Absorption Chiller Driven by Evacuated Glass Tube Solar Collector for Cooling Application in Residential Buildings

Experimental Investigation on a Novel Air-Cooled Single Effect LiBr-H2O Absorption Chiller with Adiabatic Flash Evaporator and Adiabatic Absorber for Residential Application

Comprehensive thermodynamic and operational optimization of a solar-assisted LiBr/water absorption refrigeration system

Exergy and exergoeconomic comparative analysis of three NH3–NaSCN absorption refrigeration cycles driven by solar collector

Performance Assessment of A Single/Double Hybrid Effect Absorption Cooling System Driven by Linear Fresnel Solar Collectors with Latent Thermal Storage

Comparative Study on the Energy Performance of Two Different Absorption-Compression Refrigeration Cycles Driven by Low-Grade Heat

PERFORMANCE STUDY OF A SOLAR COOLING SYSTEM WITH PTC AND A DOUBLE-EFFECT ABSORPTION CHILLER

Performance optimization and comparison towards compact and efficient absorption refrigeration system with conventional and emerging absorbers/desorbers

Energy and Exergy Performance Analysis of Solar-Assisted Thermo-Mechanical Vapor Compression Cooling System

Technical Engineering Design, Thermal Experimental and Economic Simulation Analysis of Absorption Cooling/heating Systems in China

Experimental Study of a New Ejector-Absorption Refrigeration Cycle Driven by Multi-Heat Sources

Comparative energy and exergy analysis of water-LiBr absorption chiller configurations with ejector integration, and implementation of artificial neural network on the optimal selection

Thermoeconomic performance assessment of a novel solar-powered high-temperature heat pump/adsorption cogeneration system