Abstract:The effectiveness of tunnel monitoring is a challenging task due to the limitations of monitoring gauges and lack of monitoring sections. To address this, a novel theoretical analysis-based monitoring method for tunnel structures was proposed in this study. A theoretical approach was employed to establish the correlation between external loads and structural stress–strain response in tunnel lining during grouting and stability periods. A method has been developed to derive the distribution of external loads and internal forces throughout the entire tunnel using strain monitoring at specific locations on the structure. This method has been further validated through a case study of the Liucun Tunnel, providing insights into the accuracy of the monitoring approach. It is found that during the grouting period, the segment ring is surrounded by grout, resulting in peak external loads and internal forces. As the tunnel lining enters the load stability period, both the external loads and internal forces gradually decrease and stabilize. Comparing the results of the monitored method for deriving tunnel external loads, structural bending moments and axial forces with the on-situ measurements, the new monitoring method yields errors in the response of tunnel external loads and internal forces. The average error in external loads is less than 12%, the average error in bending moments is less than 20%, and the average error in axial forces is less than 8%. The proposed monitoring method effectively addresses the issue of long-term failure of monitoring elements due to its replaceability. Additionally, utilizing theoretical methods for derivation allows obtaining more tunnel structural information based on limited monitoring data from the elements. This provides a new approach for long-term structural health monitoring. To address the existing errors in the monitoring method described in this study, the accuracy can be further improved by optimizing the model, incorporating more advanced monitoring techniques, and implementing standardized and improved construction practices.

Monitoring in Building Road Tunnel Across Coal Measures

On-Site Monitoring for the Stability Evaluation of a Highway Tunnel above Goaves of Multi-Layer Coal Seams

Structural Monitoring of Metro Infrastructure During Shield Tunneling Construction.

Numerical analysis and control technology of gas accumulation in a large-scale specially-shaped tunnel passing through coal bearing strata

Application of monitoring measurement technology in Qiaozhuang tunnel

Monitoring and field tests for controlling large tunnel deformation in squeezing ground: a case study

Monitoring Method of Large Section Bifurcated Small Clear Distance Tunnel During Information Construction Control

STUDY ON SITE MONITORING OF LARGE-SECTION HIGHWAY TUNNELS WITH SMALL CLEAR SPACING

A tunnel structure health monitoring method based on surface strain monitoring

Monitoring and Survey of Tunnel NATM on the Yuxiang Highway

Evaluation of blasting parameters for hydraulic tunnels based on multiple monitoring information

MONITORING AND CHARACTERISTICS STUDY OF STRESS EVOLUTION OF SURROUNDING ROCK DURING DEEP TUNNEL EXCAVATION

Monitoring and Analysis of Xintangfang Tunnel Construction

Monitoring and Analysis of Tunnel Surface Stability

Control and Monitoring for Blasting Vibration During Excavation of the Shallow and Long Span Tunnel

CRACKING IN TWIN-ARC HIGHWAY TUNNELS AND ITS PREVENTION MEASURES

Research on Monitoring Measures of Tunnel Structure under High Water-Pressure

Study of Prevention and Control Technology for Roadway Excavation under the Soft and Extra-Thick Coal Roof in Luling Coal Mine

Overview of Tunnel Detection Technology

Application of sensor in monitoring impact of tunnel excavation on above iron tower

Construction Technology and Application of TBM in Shengli Tunnel of Tianshan Mountain under poor geological conditions