Abstract:Poplar cultivated with Short Rotation Forestry (SRF) technique could be an important source of biomass. This dedicated crop could be produced to obtain solid biofuel transformed through combustion, pyrolysis or gasification into heat and power in CHP plants. In this work a kinetic study of the slow pyrolysis process of poplar wood (populus L.) is investigated with a thermogravimetric analyzer. A comparison of selected non-isothermal methods for analyzing solid-state kinetics data is presented. The weight loss was measured by TGA in nitrogen atmosphere. The samples were heated over a range of temperature from 298K to 973K with four different heating rates of 2, 5, 10, 15Kmin−1. The results obtained from thermal decomposition process indicate that there are three main stages such as dehydration, active and passive pyrolysis. In the DTG thermograms the temperature peaks at maximum weight loss rate changed with increasing heating rate. The activation energy and pre-exponential factor obtained by Kissinger method are 153.92kJmol−1 and 2.14×1012min−1, while, the same average parameters calculated from FWO and KAS methods are 158.58 and 157.27kJmol−1 and 7.96×1013 and 1.69×1013min−1, respectively. The results obtained from the first method represented actual values of kinetic parameters which are the same for the whole pyrolysis process, while the KAS and FWO methods presented apparent values of kinetic parameters, because they are the sum of the parameters of the physical processes and chemical reaction that occur simultaneously during pyrolysis. Experimental results showed that values of kinetic parameters obtained from three different methods are in good agreement, but KAS and FWO methods are more efficient in the description of the degradation mechanism of solid-state reactions. The devolatilization process was mathematically described by first order single reaction. The results of the kinetic study can be used in modeling devolatilization process through computational fluid dynamics (CFDs) to simulate mass and energy balances.

Physicochemical investigation and thermogravimetric analysis of bamboo and poplar wood residues and tire rubber waste: Kinetic and thermodynamic analyses

Kinetics of Bamboo Pyrolysis

Investigation on Kinetics of Bamboo Pyrolysis

Evaluation of Kinetic and Thermodynamic Parameters of Pyrolysis and Combustion Processes for Bamboo Using Thermogravimetric Analysis

Understanding pyrolysis mechanisms of pinewood sawdust and sugarcane bagasse from kinetics and thermodynamics

Autothermal Pyrolysis of Lignocellulosic Biomass: Experimental, Kinetic, and Thermodynamic Studies

Co-pyrolysis of Corn Stover and Waste Tire: Pyrolysis Behavior and Kinetic Study Based on Fraser-Suzuki Deconvolution Procedure

Thermogravimetric Analysis and Kinetic Study of Poplar Wood Pyrolysis

Insight into kinetic and Thermodynamic Analysis methods for lignocellulosic biomass pyrolysis

Investigating Kinetic Behavior and Reaction Mechanism on Autothermal Pyrolysis of Polyethylene Plastic

Pyrolysis Kinetics and Thermodynamic Parameters of Bamboo Residues and Its Three Main Components Using Thermogravimetric Analysis

Insight into Pyrolysis Kinetics of Lignocellulosic Biomass: Isoconversional Kinetic Analysis by the Modified Friedman Method

Poplar wood torrefaction: Kinetics, thermochemistry and implications

Thermogravimetric analysis and reaction kinetics of lignocellulosic biomass pyrolysis

Study on Pyrolysis Kinetics of Bamboo

Pyrolysis Characteristics and Determination of Kinetic and Thermodynamic Parameters of Raw and Torrefied Chinese Fir

Isoconversional Kinetics of Pyrolysis of Vaporthermally Carbonized Bamboo

Studies on the Mechanism of Poplar-wood Flash Pyrolysis Process

Experimental Investigation of Kinetic Parameters of Bamboo and Bamboo Biochar Using Thermogravimetric Analysis Under Non-isothermal Conditions

Novel Insights into the Kinetics, Evolved Gases and Mechanisms for Biomass (sugar Cane Residue) Pyrolysis.

Comparative Investigation on the Pyrolysis of Crop, Woody, and Herbaceous Biomass: Pyrolytic Products, Structural Characteristics, and CO2 Gasification