Influence of cloud microphysical processes on black carbon wet removal, global distributions, and radiative forcing
Junfeng Liu,Songlin Xiang,S. Tao,K. Yi,Xiurong Hu,Yuqing Wang,Jiayu Xu,Jiachen Zhang,G. Ban-Weiss
DOI: https://doi.org/10.5194/ACP-19-1587-2019
IF: 6.3
2018-09-27
Atmospheric Chemistry and Physics
Abstract:Abstract. Parameterizations that impact wet removal of black carbon (BC)
remain uncertain in global climate models. In this study, we enhance the
default wet deposition scheme for BC in the Community Earth System Model (CESM)
to (a) add relevant physical processes that were not resolved in the
default model and (b) facilitate understanding of the relative importance
of various cloud processes on BC distributions. We find that the enhanced
scheme greatly improves model performance against HIPPO observations
relative to the default scheme. We find that convection scavenging, aerosol
activation, ice nucleation, evaporation of rain or snow, and below-cloud
scavenging dominate wet deposition of BC. BC conversion rates for processes
related to in-cloud water–ice conversion (i.e., riming, the Bergeron
process, and evaporation of cloud water sedimentation) are relatively
smaller, but have large seasonal variations. We also conduct sensitivity
simulations that turn off each cloud process one at a time to quantify the
influence of cloud processes on BC distributions and radiative forcing.
Convective scavenging is found to have the largest impact on
BC concentrations at mid-altitudes over the tropics and even globally. In
addition, BC is sensitive to all cloud processes over the Northern
Hemisphere at high latitudes. As for BC vertical distributions, convective
scavenging greatly influences BC fractions at different altitudes.
Suppressing BC droplet activation in clouds mainly decreases the fraction of
column BC below 5 km, whereas suppressing BC ice nucleation increases that
above 10 km. During wintertime, the Bergeron process also significantly
increases BC concentrations at lower altitudes over the Arctic. Our
simulation yields a global BC burden of 85 Gg; corresponding direct
radiative forcing (DRF) of BC estimated using the Parallel Offline Radiative
Transfer (PORT) is 0.13 W m−2, much lower than previous studies. The
range of DRF derived from sensitivity simulations is large, 0.09–0.33 W m−2,
corresponding to BC burdens varying from 73 to 151 Gg. Due to
differences in BC vertical distributions among each sensitivity simulation,
fractional changes in DRF (relative to the baseline simulation) are always
higher than fractional changes in BC burdens; this occurs because relocating BC
in the vertical influences the radiative forcing per BC mass. Our results
highlight the influences of cloud microphysical processes on BC concentrations
and radiative forcing.
Environmental Science,Physics