Abstract:Information on pedestrian-level wind (PLW) speed for wind comfort assessment can be obtained by wind-tunnel measurements or Computational Fluid Dynamics (CFD) simulations. Wind-tunnel measurements for PLW are routinely performed with low-cost techniques such as hot-wire or hot-film anemometers, Irwin probes or sand erosion, while Laser-Doppler Anemometry (LDA) and Particle-Image Velocimetry (PIV) are less often used because they are more expensive. CFD simulations are routinely performed by the relatively low-cost steady Reynolds-Averaged Navier–Stokes (RANS) approach. Large-Eddy Simulation (LES) is less often used because of its larger complexity and cost. This paper reviews wind-tunnel and CFD techniques to determine PLW speeds expressed generally in terms of amplification factors defined as the ratio of local mean wind speed to mean wind speed at the same position without buildings present. Some comparative studies systematically indicate that the low-cost wind-tunnel techniques and steady RANS simulations can provide accurate results (∼10%) at high amplification factors (>1) while their accuracy can deteriorate at lower amplification factors (<1). This does not necessarily compromise the accuracy of PLW comfort assessment, because the higher amplification factors provide the largest contribution to the discomfort exceedance probability in the comfort criterion. Although LDA, PIV and LES are inherently more accurate techniques, this paper supports the continued use of faster and less expensive techniques for PLW studies. Extrapolating a previous saying, we argue that pedestrian-level wind comfort is one of the few topics in wind engineering where nature is kind to us concerning turbulent flows.

A novel wind comfort evaluation method for different airflows by considering dynamic characteristics of wind direction and velocity

A study of the characteristics of dynamic incoming flow directions of different airflows and their influence on wind comfort

Practical Analysis of Wind-Induced Human Comfort Condition of Tall Buildings

Multi-fanning Based Simulated Natural Wind Environment and Its Comfort Performance under Warm-to-hot Conditions

Multi-fanning and its improvement of thermal and wind comfort: An auxiliary means to air conditioning

A numerical investigation of the influence of wind on convective heat transfer from the human body in a ventilated room

Application Of Dynamic Airflows In Buildings And Its Effects On Perceived Thermal Comfort

Human thermal comfort under simulated natural wind with different turbulence intensities

Influence of Dynamic Environment with Different Airflows on Human Performance

The Differences And Connections Between The Dynamic Characteristics Of Natural And Mechancial Wind In Built Environment

Comparing the effects of sun and wind on outdoor thermal comfort: A case study based on longitudinal subject tests in cold climate region

Improving Residential Wind Environments by Understanding the Relationship Between Building Arrangements and Outdoor Regional Ventilation

Studies on the Fluctuation Characteristics of Airflow in the Built Environment

Ventilation Characteristics and Performance Evaluation of Different Window-Opening Forms in a Typical Office Room

Fluctuation characteristics of airflow in built environment

Impact of Dynamic Airflow on Human Thermal Response

Study on simulated natural wind based on spectral analysis

Research on the Impact of Air Temperature and Wind Speed on Ventilation in University Dormitories under Different Wind Directions (Northeast China)

New development of airflow fluent characteristics and its impact on human thermal comfort

Pedestrian-level wind conditions around buildings: Review of wind-tunnel and CFD techniques and their accuracy for wind comfort assessment

Dynamic Thermal Environment And Thermal Comfort