Abstract:The gap flow field formed by two rotating cylinders and the fiber orientation in the gap flow field are studied numerically. The finite volume method on the collocated body fitted grid is used for solving the field. On the assumption that there is no relative motion between the fibers and the fluid, the motion of the fibers is determined. The velocities of fibers are calculated by bi-linear interpolation method. The orientation of fibers is obtained by solving the Jeffery equation. Periodic boundary conditions are used for the fiber motion to ensure that the fibers keep staying in the computational area. Two cases i.e., two cylinders rotate in the opposite directions with the same speed and only the mandrel cylinder rotates, are considered. Physical quantities, such as velocity and pressure, for each case are obtained. For the first case, the velocity and pressure are completely symmetric about the mid-line of the computational area and the absolute values of the maximum and minimum velocity are equal due to the fact that both the casing and mandrel cylinders rotate at the same speed. The absolute values of the maximum and minimum pressure are not equal because the radii of the two cylinders are different. For the second case that only the mandrel cylinder rotates, the symmetries of the velocity and pressure about the mid-line of the computational area can also be found although the absolute values of the maximum and minimum velocity are not equal because of the different velocities of the two cylinders. Fiber motions and orientations at different times for both cases are captured. The twisting of fibers (matrix) can be observed vividly. For the case that the casing and the mandrel cylinders rotate in the opposite directions, fibers move and orientate in a two-layer structure. While for the case that only the mandrel cylinder rotates, fibers move and orientation in a single-layered structure. For both cases, the fibers have a strong tendency to align along the stream lines of the field. The influence of the slenderness ratio of fibers on fiber orientation is also studied. A stronger tendency to align along the stream lines of the field can be found as the slenderness ratio of fibers increases.

Flow Velocity Deviation of Spinning Solution under Multi-field Coupling

Spinning solution flow model in the nozzle and experimental study of nanofibers fabrication via high speed centrifugal spinning

Research on rotary nozzle structure and flow field of the spinneret for centrifugal spinning

Fiber Trajectory Tracking of Centrifugal Spinning and Coupled-Forces Field Effects on Jet Motion Stability

Orthogonal Optimization Research on Various Nozzles of High-Speed Centrifugal Spinning

The Movement and Forces of Spinning Solution in the Nozzle During High-Speed Centrifugal Spinning

Jet slipping mechanism and fabricating of composite fiber by multiple field coupling

Three Dimension Two Phase Flow Field Numerical Simulation on Tail-Pipe Nozzle SRM under Spinning Condition

Formation Mechanism and Control of Flaring in Forward Tube Spinning

Dynamic Simulation of Fiber Orientation in the Gap Flow Field Between Two Rotating Cylinders

The Bent-Tube Nozzle Optimization of Force-Spinning with the Gray Wolf Algorithm.

Process Analysis and Experimental Investigation of Multi-Pass Offset Spinning

Numerical Simulation Of Fiber Spinning Process With Structure Evolution Of Polymer Chains

Simulation of polymer solution slip motion and composite fiber fabrication in rotary jet spinning

A Numerical and Experimental Study on the Effect of the Cone Angle of the Spindle in Murata Vortex Spinning Machine

Optimization Mechanism of Nozzle Parameters and Characterization of Nanofibers in Centrifugal Spinning

Flow Field in Micro-Triangle of Centrifugal Composite Spinning and the Effect of Slippage on PA Composite Nanofibers

Modeling of Spinning Jet Behavior and Evaluation on Fiber Morphology for Centrifugal Spinning

Simulation of fiber suspension flowing through a stock pump impeller with two-way coupling

Numerical simulation of flow field in the pneumatic compact spinning systems using Finite Element Method

Response Surface Methodology to Explore the Influence Mechanism of Fiber Diameter in a New Multi-Needle Electrospinning Spinneret