Abstract:Latent heat storage is one of the most efficient ways of storing thermal energy. Organic phase change materials are latent heat storage materials and they have been widely used as suitable materials for thermal energy storage applications due to their high latent heat and small temperature difference between storing and releasing heat. In this thesis, micro- and nano- scaled phase change materials were fabricated for thermal energy storage. A novel microencapsulated phase change material slurry (MPCS) was introduced by dispersing microencapsulated phase change materials (MEPCMs) into water with an amount of surfactants and its thermal and rheological properties were also investigated. The results showed that MPCS fabricated in the current research are suitable for potential application as heat transfer media in the thermal energy storage. A new methodology was proposed to investigate the heat transfer characteristics of MPCSs. Experiments were carried out in laminar, transition and turbulent flow for MPCSs in a circular tube under constant heat flux, respectively. The experimental results demonstrated that in comparison to water as a heat transfer fluid at the same flow rate, the heat transfer of 10 wt. % MPCS could be enhanced by 10 % in transition flow condition while the PCM particles were in solid/liquid state, and the heat transfer of 5 wt. % MPCS could be enhanced by 21.9 % and 19.2 % in turbulent flow condition while the PCMs are in solid and solid/liquid states, respectively. Nevertheless, the heat transfer enhancement depends on the combination factors, including concentration of the slurry and flow rate of the slurry. A novel heat transfer fluid containing microencapsulated phase change material and multi-walled carbon nanotubes was prepared. The results showed that addition of MWCNTs to microencapsulated phase change material slurry can effectively improve the thermal conductivity of suspensions and it is also found that a blend of 10 wt. % MEPCM and 1 wt. % MWCNTs suspension can achieve the best thermal performance and stability among other blends in the experiment. A novel nanocapsule containing n-octadecane with an average 50 nm thick shell of poly (ethyl methacrylate) (PEMA), and with a core/shell weight ratio of 80/20 was synthesized by direct miniemulsion method. The results showed that PEMA/octadecane nanocapsule had good thermo-physical properties and had much higher encapsulation ratio (89.5%) and encapsulation efficiency (88.9%). For the first time, a novel PCM nanoparticle suspension (nano-PCS) was synthesized by direct miniemulsion method for thermal energy system application. It was found that the nano-PCSs had good thermo-physical properties and durability. All nano-PCSs presented narrow size distribution and stable particles. In comparison to the convectional PCM emulsion and MPCS, the nano-PCS tends to be more stable and is much easier and cheaper to fabricate in terms of the method and materials used, however, the heat transfer characteristics of the nano-PCS require further experimental investigation

The Preparation of a Suspension of Microencapsulated Phase Change Material (MPCM) and Thermal Conductivity Enhanced by MXene for Thermal Energy Storage

Research on the modification of microencapsulated phase change material for thermal energy storage by nano-SiO2 and graphite

Thermal conductivity enhancement of phase change materials for thermal energy storage: A review

Encapsulation of Phase Change Materials Via Interfacial Miniemulsion Polymerization for High Thermal Energy Storage Density

Preparation and Characterization of Poly (Mma-Co-aa)/paraffin Microencapsulated Phase Change Material for Thermal Energy Storage

Experimental Investigation of Performances of Microcapsule Phase Change Material for Thermal Energy Storage

Preparation, Heat Transfer and Flow Properties of Microencapsulated Phase Change Materials for Thermal Energy Storage

Fabrication, Characterization and Thermo-Physical Properties of Micro- and Nano- Scaled Phase Change Materials for Thermal Energy Storage

Preparation, Characterization, and Thermal Properties of Microencapsulated Phase Change Material for Low-Temperature Thermal Energy Storage

MXene-decorated bio-based porous carbon composite phase change material for superior solar-thermal energy storage and thermal management of electronic components

Stability and Thermophysical Properties of Binary Propanol–Water Mixtures-Based Microencapsulated Phase Change Material Suspensions

Experimental investigation on the stability and heat transfer enhancement of modified mircoencapsulated phase change materials and latent functionally thermal fluids

Dynamic Thermal Characteristics Analysis of Microencapsulated Phase Change Suspensions Flowing Through Rectangular Mini-Channels for Thermal Energy Storage

Experimental Investigation On Laminar Forced Convection Heat Transfer Enhancement Of Microencapsulated Phase Change Suspension With Constant Heat Flux

Microencapsulation and Thermal Properties of Myristic Acid with Ethyl Cellulose Shell for Thermal Energy Storage

An Experimental Study of Convective Heat Transfer with Microencapsulated Phase Change Material Suspension: Laminar Flow in A Circular Tube under Constant Heat Flux

Natural Microtubule-Encapsulated Phase-Change Material with Simultaneously High Latent Heat Capacity and Enhanced Thermal Conductivity

Experimental and Photothermal Performance Evaluation of Multi-Wall Carbon-Nanotube-Enhanced Microencapsulation Phase Change Slurry for Efficient Photothermal Conversion and Storage

Thermal comfort and energy saving of novel heat-storage coatings with microencapsulated PCM and their application

Experimental Study on the Stability and Thermophysical Properties of Binary Propanol-Water Mixtures Based Phase Change Microencapsule Suspensions

EXPERIMENTAL RESEARCH ON LAMINAR FORCED CONVECTION HEAT TRANSFER CHARACTERISTICS OF MICROENCAPSULATED PHASE CHANGE MATERIAL SUSPENSION