Abstract:The application of morphing wing enables vehicles to show better aerodynamic performance in various flight conditions. This article proposes a modular bilateral triangular pyramid (BTP) unit-based morphing wing skeleton (MWS) mechanism that may achieve continuous variable span-wise bend, span-wise twist, and sweep. A lockable morphing (LM) unit with the BTP unit is designed. Based on the Denavit-Hartenberg coordinate method and motion influence coefficient method, the kinematics of MWS mechanism is conducted. The theoretical models of the kinematic characteristics of the MWS mechanism during the three morphing patterns are obtained. The kinematic simulation models of three morphing configurations of the MWS mechanism are performed. The driving speed ratio of the linear actuator of span-wise bend and twist is analyzed during the twisting phase, and the analysis shows that there be a speed ratio minimizes the coupling bend angle. By comparing the results between the theoretical and simulation models, the accuracies of kinematic theoretical models under different morphing configurations are verified. At last, this article conducted a two-way fluid-structure interaction (FSI) analysis of morphing wing to obtain the influence of aerodynamic load on the flexible skin and skeleton mechanism, as well as the influence of structural deformation on the aerodynamic characteristics. Results show that the initial and swept states have the greatest impact on the out of plane bearing capacity of the flexible skin. In addition, the out-of-plane bulging deformation located at the trailing edge of the flexible skin is beneficial for improving aerodynamic performance, while the protrusion located at the leading edge increases air resistance. These findings provide important theoretical basis for the application of the MWS mechanism.

Fluid–Structure Coupling and Aerodynamic Performance of a Multi-Dimensional Morphing Wing with Flexible Metastructure Skin

Design, kinematic and fluid-structure interaction analysis of a morphing wing

Research on Large-Deformation Trapezoidal Skin Structure of Morphing Wings

Structure Designation and Dynamic Model Analysis of Folding Wing for Underwater Vehicles

MECHANICAL MODELLING OF A MULTI-LAYER PARALLEL PRE-COMPRESSED MFC BIMORPH MORPHING WING

Fluid-structure interaction simulation for multi-body flexible morphing structures

Design of a variable-sweep wing structure with flexible shear skin

Design and Rigid-Flexible Dynamic Analysis of a Morphing Wing Eight-Bar Mechanism

A Shear-Sliding Rigid-Flexible Coupled Skin Variable-Sweep Wing Design and Heat-Fluid-Structure Multifield Coupling Analysis

Seamless Morphing Wing with SMP Skin

Structural Analysis of Morphing Airfoils for Camber Adaptive Wing

Development and Investigation for Rigid-Flexible Coupling Dynamic Performances of the Morphing Wing with Clearance Joints

Design and analysis of flexible skin based on zero Poisson's ratio hybrid honeycomb

Design and Analysis of a Variable-sweep Morphing Wing for UAV Based on a Parallelogram Mechanism

Application Status and Future Prospect of Aircraft Morphing Wing

Design and Shear Analysis of an Angled Morphing Wing Skin Module

Design and Analysis of a Variable-span and Cambered Span Morphing Wing for UAV.

Morphing Wingtip Structure Based on Active Inflatable Honeycomb and Shape Memory Polymer Composite Skin: A Conceptual Work

Design of a Sliding Morphing Skin with Segmented Rigid Panels

Elastic Composite Skin for a Pure Shear Morphing Wing Structures

Research on a variable camber wing with shape memory polymer skin