Abstract:Amid rising demands for fuel efficiency and emissions reduction, enhancing the thermal efficiency of gasoline engines has become imperative, which requires higher efficiency combustion strategies and integrated optimized design to maximize the work output from fuel. In gasoline engine, both increasing the compression ratio and using lean burn mode improve the ratio of useful work output to the energy input effectively, which resulting in higher thermal efficiency. Although there is limited scope for increasing the compression ratio due to the higher sensitivity to knocking, especially under stoichiometric conditions, reduced sensitivity could be got with leaner mixture fill into cylinder, which can further increase the specific heat ratio and thermal efficiency. However, realizing the efficiency benefits of lean burn in gasoline engines necessitates overcoming critical challenges like ensuring robust ignition process and accelerating burning rates to achieve short, stable combustion durations. To overcome these problems, a kind of pre-chamber ignition concept has been developed, which integrate a dedicate injector and spark plug into one assembly on cylinder head. In this paper, the focus is on the development of such a system and the combustion characteristics on gasoline engine with it.Primary experimental data is obtained by an ultra-lean single cylinder research gasoline engine equipped with pre-chamber concept. Key structure parameters such as pre-chamber volumetric fraction and jet hole have been comparatively investigated. Experimental study also be performed on a multi-cylinder engine equipped with the same pre-chamber concept in order to verify the maximum Gross-ITE and BTE simultaneously. Results indicated that optimized pre-chamber structure design could make much contribute to the thermal efficiency under ultra-lean mode with lambda up to 2.1. Under this condition, combustion stability was also significantly improved compared to spark ignition with faster and knock-free combustion process. Due to the lower temperature of ultra-lean combustion, Nitrogen Oxides emissions can be significantly reduced. Furthermore, for a given load, it was shown that maximum GITE of 50% on SCE was measured at 2500rpm-11.5bar IMEP together with the maximum BTE of 46.3% on MCE under the same operating condition.

Nozzle Design of Plug-and-Play Passive Pre-Chamber Ignition Systems for Natural Gas Engines

Effect of Bowl-in-Piston Chamber on the Combustion Process in a Stoichiometric Natural-Gas Spark-Ignition Engine

Optical and Numerical Investigations of Flame Propagation in a Heavy Duty Spark Ignited Natural Gas Engine

Analysis of Performance of Passive Pre-Chamber on a Lean-Burn Natural Gas Engine under Low Load

An Experimental Study of the Combustion Process in a Natural-Gas Spark-Ignition Engine

Computational analysis of the scavenging characteristic and optimization of passive pre-chamber

Experimental study of pre-chamber jet ignition in a rapid compression machine and single-cylinder natural gas engine

The influence of the enrichment injection angle on the performance of a pre-chamber spark ignition natural-gas engine

Analysis of Combustion and Emission Performance in a Lean Burn Natural Gas Engine Applied with Passive Pre-Chamber under Low Load

Numerical Research on the Effects of Pre-Chamber Orifice Scheme on the Performance in a Large-Bore Natural Gas Engine

Investigation of Performance and Emission Characteristics on a Large-Bore Spark-Ignition Natural Gas Engine with Scavenged Prechamber and Miller Cycle Attribute

Numerical Investigation of the Operating Characteristics of the Passive and Active Prechamber Jet Ignition in a Natural Gas Engine

Numerical Investigation of Pre-Chamber Jet Combustion in a Light-Duty Gasoline Engine

Pre-Chamber Combustion System Development for an Ultra-Lean Gasoline Engine

Optimization of Combustion Chamber Geometry for Natural Gas Engines with Diesel Micro-Pilot-Induced Ignition

Influence of Intake Port Structure on the Performance of a Spark-Ignited Natural Gas Engine

Effects of the Nozzle Design Parameters on Turbulent Jet Development of Active Pre-Chamber

Effects of passive pre-chamber jet ignition on combustion and emission at gasoline engine

Experimental investigation of the influence of pre-chamber structural parameters on combustion and emission characteristics of a high compression ratio SI engine

Computational Optimization of the Performance of a Heavy-Duty Natural Gas Pre-Chamber Engine

Numerical Investigation on the Performance of a 4-Stroke Engine with Different Passive Pre-Chamber Geometries Using a Detailed Chemistry Solver