Influence of different machining methods on the surface roughness of TC4: dry milling, water-based fluid wet milling, and foam spray milling

You Li,Shuncai Li,Xin Wang

DOI: https://doi.org/10.1139/tcsme-2024-0045

2024-06-23

Transactions of the Canadian Society for Mechanical Engineering

Abstract:Transactions of the Canadian Society for Mechanical Engineering, Ahead of Print. The surface quality of workpieces is influenced by various factors, including processing parameters, processing techniques, cutting force, and cutting vibration. Many researchers have studied wet cutting to minimize milling forces and vibrations. We explore a high-density water-based foam milling method. By this method the foam is sprayed onto the surface area of tool and workpiece to absorb vibration energy. Firstly, a milling test system was established to conduct tests on TC4 titanium alloy under three different machining conditions (dry milling, water-based fluid wet milling, and foam spray milling), and the three-dimensional (3D) milling forces and milling vibrations were simultaneously recorded during the milling process, and the workpiece's surface roughness was measured using a contact roughness measuring instrument. Then principal component analysis method was performed on the 3D milling forces and vibrations to obtain dimensionality-reduced feature values. Subsequently, multi-feature combination prediction models of surface roughness corresponding to the three machining conditions were developed using particle swarm optimization and a generalized regression neural network. Finally, the developed prediction models were compared and analyzed. The research results indicate that high-density water-based foam spray milling can effectively reduce the milling force by 70% and the milling vibration by 85% at most. Foam spray milling reduces the average roughness by up to 49%. The roughness prediction accuracy reaches 95.43%, with an error of less than 0.054 μm.

engineering, mechanical