Abstract:Utilizing catalysts to accelerate the redox kinetics of lithium polysulfides (LiPSs) is a promising strategy to alleviate the shuttle effect of lithium-sulfur (Li-S) batteries. Nevertheless, most of the reported catalysts are only effective for LiPSs reduction, resulting in the devitalization of catalysts over extended cycles as a consequence of the continuous accumulation of Li2S passivation layer. The situation gets even worse when employing mono-directional catalyst with poor electron conductivity because the charge transfer for the decomposition of solid Li2S is severely hampered. Herein, a high-conductive and dual-directional catalyst Co3C decorated on porous nitrogen-doped graphene-like structure and carbon nanotube (Co3C@PNGr-CNT) is fabricated as sulfur host, which not only promotes the precipitation of Li2S from LiPSs during discharge but also facilitates the decomposition of Li2S during subsequent charge, as evidenced by the reduced activation energies for both reduction and oxidation processes. Furthermore, the long-term catalytic stability of Co3C is corroborated by the reversible evolution of Co-C bond length over extended cycles as observed from X-ray absorption fine structure results. As a consequence, the fabricated Co3C@PNGr-CNT/S cathode delivers a low capacity decay of 0.043% per cycle over 1000 cycles at 2C. Even at high sulfur loading (15.6 mg cm(-2)) and low electrolyte/sulfur (E/S) ratio (similar to 8 mu L mg(-1)) conditions, the battery still delivers an outstanding areal capacity of 11.05 mAh cm(-2) after 40 cycles. This work provides a rational strategy for designing high-efficient bidirectional catalyst with single component for high-performance Li-S batteries. (C) 2021 Science Press and Dalian Institute of Chemical Physics, Chinese Academy of Sciences. Published by ELSEVIER B.V. and Science Press. All rights reserved.

Polar Co9S8 anchored on Pyrrole-Modified graphene with in situ growth of CNTs as multifunctional Self-Supporting medium for efficient Lithium-Sulfur batteries

A Nitrogen/Oxygen Dual-Doped Porous Carbon with High Catalytic Conversion Ability Toward Polysulfides for Advanced Lithium–Sulfur Batteries

Bimetallic Nanoparticles Decorated Porous Carbon As the Host Material to Enhance the Performance of Lithium-Sulfur Batteries

Construction of Binary Metal Sulfide Nanoparticles to Boost Catalytic Activity for Lithium-Sulfur Batteries

Surface-coated AlF3 Nanolayers Enable Polysulfide Confinement Within Biomass-Derived Nitrogen-Doped Hierarchical Porous Carbon Microspheres for Improved Lithium-Sulfur Batteries

Nitrogen-doped Carbonaceous Scaffold Anchored with Cobalt Nanoparticles As Sulfur Host for Efficient Adsorption and Catalytic Conversion of Polysulfides in Lithium-Sulfur Batteries

Confined Co9S8 nanocrystals into N/S-Co-doped Carbon Nanofibers as A Chainmail-like Electrocatalyst for High-performance Lithium-Sulfur Batteries with High Sulfur Loading

Highly active CoP-Co2N confined in nanocarbon enabling efficient electrocatalytic immobilizing-conversion of polysulfide targeting high-rate lithium-sulfur batteries

Encapsulating Co9S8 nanocrystals into CNT-reinforced N-doped carbon nanofibers as a chainmail-like electrocatalyst for advanced Li-S batteries with high sulfur loading

Efficient Co 0.85 Se-CNT sulfur cathode derived from strong catalyst-support interactions: Contribution of adsorption-catalysis mechanism to the redox kinetics of polysulfides

Coupling highly dispersed Sb2S3 nanodots with nitrogen/sulfur dual-doped porous carbon nanosheets for efficient immobilization and catalysis of polysulfides conversion

Coordinated Immobilization and Rapid Conversion of Polysulfide Enabled by a Hollow Metal Oxide/Sulfide/Nitrogen‐Doped Carbon Heterostructure for Long‐Cycle‐Life Lithium‐Sulfur Batteries

P-doped Co9S8 nanoparticles embedded on 3D spongy carbon-sheets as electrochemical catalyst for lithium-sulfur batteries

Bidirectionally Catalytic Polysulfide Conversion by High-Conductive Metal Carbides for Lithium-Sulfur Batteries

Controlled Construction of Cobalt-Doped Carbon Nanofiber-Carbon Nanotubes as a Freestanding Interlayer for Advanced Lithium-Sulfur Batteries

An Entangled Cobalt–Nitrogen–Carbon Nanotube Array Electrode with Synergetic Confinement and Electrocatalysis of Polysulfides for Stable Li–S Batteries

Macroporous Multichannel Carbon Nanofibers Embedded with Co/Fe-N Electrocatalyst as the Sulfur Host for Boosting Polysulfides Conversion in Lithium-Sulfur Batteries

Single-atomic Co-B2N2 sites anchored on carbon nanotube arrays promote lithium polysulfide conversion in lithium-sulfur batteries

Encapsulating Sulfur into a Gel-Derived Nitrogen-Doped Mesoporous and Microporous Carbon Sponge for High-Performance Lithium-Sulfur Batteries

Implanting Single Zn Atoms Coupled with Metallic Co Nanoparticles into Porous Carbon Nanosheets Grafted with Carbon Nanotubes for High‐Performance Lithium‐Sulfur Batteries

Synergistic restriction of polysulfides enabled by cobalt@carbon spheres embedded CNTs: A facile approach for constructing sulfur cathodes with high sulfur content