Abstract:As a typical form of internal erosion, suffusion refers to the detachment and migration of fine particles through voids among coarse particles driven by seepage flow. This paper studies the suffusion-induced evolution of mechanical and microstructural properties of granular soils using the coupled computational fluid dynamic-discrete element method (CFD-DEM). The full suffusion process is reproduced by imposing an upward seepage flow on a gap-graded specimen under the designated effective confining pressure. A series of drained triaxial tests are then performed on the eroded and noneroded specimens to obtain their stress-strain responses. The results reveal that suffusion leads to large amount of fines loss and considerable volumetric contraction, accompanied by substantial changes in the soil fabric. The microstructure alterations within the specimen, such as intermittent formation of local piping and spatial evolution of fines concentration, are continuously tracked and quantified during the simulations. It is found that suffusion significantly reduces the peak strength of the specimen under drained shearing while its impact on critical shear stress is negligible. The critical void ratio of the specimens increased after suffusion. The microstructural characteristics (i.e., coordination numbers, connectivity, void fraction distribution, and contact network statistics) are found to be responsible for the shear strength variations. Comparison with results from the eroded specimens prepared by particle removal indicates that the two procedures can generate drastically different soil microstructures and hence distinct macroscopic responses. Therefore, the preparation method for eroded specimens in DEM studies must be carefully validated, as it can lead to qualitatively different conclusions about the mechanical consequences of suffusion.

Investigating the Effects of Particle Spatial Evolutions on the Vibration-Induced Compaction Deformation of Gap-Graded Mixtures Via DEM Models

Particle Shape Effects on the Shear Behaviors of Granular Assemblies: Irregularity and Elongation

Deformation Characteristics of Inherently Anisotropic Granular Media under Repeated Traffic Loading: a DEM Study

Suffusion-Induced Evolution of Mechanical and Microstructural Properties of Gap-Graded Soils Using CFD-DEM

The Influence of Particle-Size Distribution on Critical State Behavior of Spherical and Non-Spherical Particle Assemblies

Studying on the Upper Limit of the Coarse-Grained DEM Model for Simulating Mixing Processes in a Rolling Drum with Complex Wall Boundary

Three-Dimensional Discrete Element Modelling Of Influence Factors Of Indirect Tensile Strength Of Asphalt Mixtures

Micromechanics-Based Analysis of the Effect of Aggregate Homogeneity on the Uniaxial Penetration Test of Asphalt Mixtures

Discrete Element Modeling of Aggregate Gradation Influence on the High Temperature Stability of Structural-Layer Asphalt Mixtures

Investigation of the compaction behaviour of sand-gravel mixtures via DEM: Effect of the sand particle shape under vibration loading

Investigation of the force evolution in aggregate blend compaction process and the effect of elongated and flat particles using DEM

Assessing the effect of layered spatial variability on soil behavior via DEM simulation

Micromechanical Investigation of Suffusion and Its Consequence in Gap-Graded Granular Soil at the Opening of Underground Structures Using the Coupled CFD-DEM Method

Investigating the effect of particle angularity on suffusion of gap-graded soil using coupled CFD-DEM

DEM investigation of strain behaviour and force chain evolution of gravel–sand mixtures subjected to cyclic loading

Experimental study on compaction characteristics of coarse-grained soils with typical particle shapes affected by vibration frequencies

Compaction behavior of coarse-grained soil under various vibration frequencies: a DEM study

Research on discrete element simulation of slump test for fresh self-compacting concrete

Investigation of Particle Rotation Characteristics and Compaction Quality Control of Asphalt Pavement Using the Discrete Element Method

Investigation of the effect of cementing ratio on the mechanical properties and strain location of hydrate-bearing sediments by using DEM

Study on the influence of coarse aggregate distribution uniformity on the compaction characteristics of gap-graded gravels