Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Condensation heat transfer and correlation analysis in helical tube of mixed carbon-hydro refrigerant

Forced Convective Condensation Flow and Heat Transfer Characteristics of Hydrocarbon Mixtures Refrigerant in Helically Coiled Tubes

Heat Transfer Characteristics of Hydrocarbon Mixtures Refrigerant During Condensation in a Helical Tube

The Condensation Heat Transfer Characteristics of Zeotropic Hydrocarbon Mixtures in a Helical Pipe

Heat Transfer Characteristics of Mixed Hydrocarbon Refrigerant Flow Condensation in Shell Side of Helically Baffled Shell-and-tube Heat Exchanger

Experimental Investigation of Forced Convective Condensation Heat Transfer of Hydrocarbon Refrigerant in a Helical Tube

Numerical Investigation on Condensation Heat Transfer Performance of Mixed Hydrocarbon Refrigerant in Spirally Tubes

Fundamental Research on the Condensation Heat Transfer of the Hydrocarbon-Mixture Energy in a Spiral Tube Described by a Universal Model Using Flow Pattern Based and General Modes

Numerical Study on Condensation Heat Transfer and Pressure Drop Characteristics of Ethane/propane Mixture Upward Flow in a Spiral Pipe

Numerical Study on the Condensation Flow and Heat Transfer Characteristics of Hydrocarbon Mixtures Inside the Tubes of Liquefied Natural Gas Coil-Wound Heat Exchangers

Numerical Investigation on Flow Condensation of Zeotropic Hydrocarbon Mixtures in a Helically Coiled Tube

Heat Transfer Characteristics of Two-Phase Mixed Hydrocarbon Refrigerants Flow Boiling in Shell Side of LNG Spiral Wound Heat Exchanger

Analysis of Condensation Flow and Heat Transfer Characteristics Inside Spiral Tubes

Experimental Investigation on Heat Transfer Characteristics of Two-Phase Propane Flow Condensation in Shell Side of Helically Baffled Shell-and-tube Condenser

Shell Side Condensation Heat Transfer Characteristics Of Ethane/Propane Mixtures

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Flow boiling heat transfer characteristics and correlation development of R290/R600a mixtures in an internally threaded tube{fr}Caractéristiques de transfert de chaleur par ébullition en écoulement et développement de corrélations pour les mélanges R290/R600a dans un tube fileté interne

A simulation study on the condensation flow and thermal control characteristics of mixed refrigerant in a dimpled tube

Thermodynamic Analysis of Structural Parameters During Condensation in Spiral Tubes

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Condensation Flow Patterns and Heat Transfer Correction for Zeotropic Hydrocarbon Mixtures in a Helically Coiled Tube