Abstract:Using Atomsk and LAMMPS to construct nine bicrystal Mg models with preset voids and symmetric tilt grain boundaries, tensile simulations were performed at the same rate. The results showed that as the symmetric tilt grain boundary angle increased from 20° to 30°, the yield stress decreased from 2.28 to 1.42 GPa. Based on the plastic deformation and stress–strain curves, the nine bicrystal magnesium models with different symmetric tilt grain boundaries can be divided into two groups: the first group ranges from 20° to 40°, and the second group from 45° to 80°. A representative case is selected from each group. In the first group of models, the main modes of plastic deformation are grain boundary migration, basal dislocation slip, and stacking faults; whereas in the second group, there is a higher number of basal dislocation slips, leading to a greater quantity of stacking faults, and thus a stronger capacity for plastic deformation.2 A twin‐crystal magnesium (Mg) model with 9 different symmetric tilt grain boundary (STGB) angles (20°–80°) with preset nanohole defects is established by atomsk and lammps software. The mechanical behavior of grain boundary (GB) angles on twin‐crystal Mg with cavity defects and its cavity evolution are simulated by the molecular dynamics method with embedded atomic potential, and the plastic deformation mechanism is revealed. The results show that the yield stress decreases with the increase of the STGB Angle during the stretching process. When the GB Angle increases from 20° to 80°, the yield stress decreases from 2.28 to 1.42 Gpa. This is because the larger the STGB Angle is, the larger the Schmidt factor is, and the easier it is to start dislocation slip during the stretching process. On the other hand, the larger the Angle of STGB, the more the number of atomic voids at the interface, and the more the number of dislocation nucleation points. The larger the Angle of STGB, the lower the strength of twinning Mg but the better the plasticity to avoid fracture. The plastic deformation mechanism mainly includes the nucleation of Shockley incomplete dislocation at STGBs, dislocation slip generates stacking faults (SFs), GB migration, and base plane dislocations.

Inter-granular and Intra-granular Crack Behavior in Mg Bicrystal of [ 12 10 ] Symmetric Tilt Grain Boundary: LEFM Prediction and Atomic Simulation

Grain boundary effects on the inelastic deformation behavior of bicrystals

Plastic deformation response during crack propagation in Mg bicrystals with twin boundaries

Elastic-plastic Stress Distribution Near Grain Boundary in Anisotropic Bicrystals and Tricrystals Considering Two Kinds of Grain Boundaries

Influence of Grain Boundary on Fatigue Behavior of Ni-base Bicrystals

Intergranular fracture, grain-boundary structure, and dislocation-density interactions in FCC bicrystals

Phase-field-crystal study on the evolution behavior of microcracks initiated on grain boundaries under constant strain

Shear Response of Grain Boundaries with Metastable Structures by Molecular Dynamics Simulations

Role of Misorientation Angle in Twinning and Dislocation Slip for Nano Mg Bicrystals with [2-1-10] Symmetric Tilt Grain Boundaries under Uniaxial Compression and Tension

Dynamic Crack Propagation in Copper Bicrystals Grain Boundary by Atomistic Simulation

Effects of Crystalline Orientation, Twin Boundary and Stacking Fault on the Crack-Tip Behavior of a Mode I Crack in Nanocrystalline Titanium

Orientation Effect on Intergranular Fracture Behaviors along Symmetrical Tilt Grain Boundaries in Bcc Iron

Crack-tip Cleavage/dislocation Emission Competition Behaviors/mechanisms in Magnesium:Alefm Prediction and Atomic Simulation

Study on the Plastic Deformation Mechanism of Void‐Containing Twin‐Crystal Magnesium with Symmetric Tilt Grain Boundary Angles

Studying Crack Propagation along Symmetric Tilt Grain Boundary with H Segregation in Ni by MD Simulation

Dislocation–grain boundary interaction-based discrete dislocation dynamics modeling and its application to bicrystals with different misorientations

Effect of Blunt Nanocracks on the Splitting Transformation of Grain Boundary Dislocation Piled Up at Triple Junctions

A new method for predicting dislocation emission of grain boundary in bicrystal Mg

On Intrinsic Brittleness and Ductility of Intergranular Fracture along Symmetrical Tilt Grain Boundaries in Copper

Influences of Symmetric Tilt Grain Boundary on the Stretching Deformation Behaviors of Cu Bicrystals

Molecular Dynamics Simulation of Fracture Behaviors of 〈110〈 Tilt Grain Boundaries in Γ-Tial