Abstract:The present paper is aimed at introducing its experimental research of the flame spreading mechanism over charring materials facing the orientation under the natural convection in the direction of gravity assistance. In this research we have chosen wood sheets as typical charring materials while the burning process was observed at an angle of orientation α from 20° to 90° (, i.e. a vertically upward burning). Data the paper has adopted are taken to show the flame spreading characteristics of thermodynamically thick-enough charring materials. Thus we have found that the flame behavior over the solid surface may go through such states as extinguishment after removing the igniter, steady burning, accelerated burning and full burning similar to the flash with the constantly increasing burning angle. But the local flame spreading rate actually fluctuates increasingly with the angle. And when the flame spreading behaviors for the sample thickness d=2mm is compared to that for the sample thickness d=3mm, it can be found that the thinner the sample is the more sensitive to the angle change. The flame parameters such as the flame angle θ, flame length L can be measured for the sample thickness d=3mm. The above parameters also contribute to the deduction of the calculated flame spreading rates, which can be compared with the experimental results. In the range of 0°α60°, the predicted flame spreading rates prove to be in well conformity with the experimental flame spreading rates, but in the range of α≥60°, the discrepancy is also to be noted. Measurements of the temperature distribution on the upper and rear surfaces of the samples have also been carried out by using the fine thermocouples. Based on the temperature data, the contributory factors of the flames over both up and rear surface to the flame spreading behavior are also discussed here in the paper. For α30°, the flame over the ear-surface is predominant for the whole burning process and the flame over up-surface is predominant just for α≥30°.

Experimental Study of the Burning Characteristics of Wood Grilles with Different Porosities

Effect of porosity on ignition and burning behavior of cellulose materials

Influence of woodgrain orientation on the upward flame spread over discrete wood chips

Fire Spread over Charring Materials: Influence of the Sample Orientation and External Radiant Intensity

Experimental Study on Characteristics of Flame Spread over Inclined Wood Sheets

EXPERIMENTAL STUDY ON CHARACTERISTICS OF FLAME SPREAD OVER THE SURFACE OF WOOD SHEETS WITH DIFFERENT WIDTH UNDER DIFFERENT INCLINED ANGLE

Experimental study on influence of air gap on upward flame spread over discrete fuel

Effect of Temperature of Premixed Gas and Porous Wall Characteristic on the Flames on Porous Wall Surface

Investigation on the double-sided concurrent flame spread behavior of log planks

Experimental Study on the Burning Characteristics of Wood Cribs in a Confined Space

Modulation of Heat Transfer in a Porous Burner Based on Triply Periodic Minimal Surface

Effect of Gap and Orientation of Thermal Barrier Plates on Ignition and Downward Crossing Flame Spread Over a Wood Board

Smouldering Limit in Frictional Heating of Wood - Pilot Study

Pore-scale study of flame propagation and thermal characteristics in randomly packed beds

Modeling of the Pore Structure Evolution in Porous Char Particles During Combustion

Experimental Study on Releasing Characterization of Smoke from Burning of Several Typical Woods

Influence of Stack Effect on Flame Shapes of Gas Burner Fires

A Comparative Experimental Study on Heat Release Rates of Charring and Noncharring Solid Combustible Materials

Experimental Study on Flame Height and Plume Centerline Temperature Decay Power Index for a Porous Gas Burner Fire

Sample Width and Thickness Effects on Upward Flame Spread over PMMA Surface.

Heat Transfer Mechanisms in Horizontal Flame Spread over Wood and Extruded Polystyrene Surfaces