Abstract:The single-pass geosynchronous synthetic aperture radar interferometry (GEO InSAR) adopts the formation of a slave satellite accompanying the master satellite, which can reduce the temporal decorrelation caused by atmospheric disturbance and observation time gap between repeated tracks. Current formation design methods for spaceborne SAR are based on the Relative Motion Equation (RME) in the Earth-Centered-Inertial (ECI) coordinate system (referred to as ECI-RME). Since the Earth rotation is not taken into account, the methods will lead to a significant error for the baseline calculation while applied to formation design for GEO InSAR. In this paper, a formation design method for single-pass GEO InSAR based on Coordinate Rotational Transformation (CRT) is proposed. Through CRT, the RME in Earth-Centered-Earth-Fixed (ECEF) coordinate system (referred to as ECEF-RME) is derived. The ECEF-RME can be used to describe the accurate baseline of close-flying satellites for different orbital altitudes, but not limited to geosynchronous orbit. Aiming at the problem that ECEF-RME does not have a regular geometry as ECI-RME does, a numerical formation design method based on the minimum baseline error criterion is proposed. Then, an analytical formation design method is proposed for GEO InSAR, based on the Minimum Along-track Baseline Criterion (MABC) subject to a fixed root mean square of the perpendicular baseline. Simulation results verify the validity of the ECEF-RME and the analytical formation design method. The simulation results also show that the proposed method can help alleviate the atmospheric phase impacts and improve the retrieval accuracy of the digital elevation model (DEM) compared with the ECI-RME-based approach.

Formation Design of Distributed Satellites InSAR Based on DEM and GMTI

A Formation Design Approach of the Distributed Spaceborne InSAR Based on Height-measure Optimal Accuracy Value

Formation Configuration, Orbit Design and Baseline Performance Analysis Based on DEM and GMTI

The Optimal Formation Configurations for Both GMTI and DEM Using Distributed Satellites InSAR

Restriction of Spaceborne Multistatic InSAR Formation Configuration Design

Interferometric baseline design and performance evaluation for 3-dimensional formation flying SAR satellites system

Optimization Design Approach of Distributed Spaceborne InSAR Formation

Formation Optimized Design for the Height Measurement of InSAR Using Distributed Micro-Satellites

Formation Design and Baseline Optimization of GEO SAR Interferometry

Optimization and Design of Baseline Direction of Satellite InSAR System

Baseline Design and Performance Analysis for Distributed Spaceborne Interferometric Synthetic Aperture Radar

Formation Design for Single-Pass GEO InSAR Considering Earth Rotation Based on Coordinate Rotational Transformation

A Method of Dual-Interferometry Moving Targets Indication Based on Spaceborne Parasitic Distributed SAR

Interferometric Measurement of Terrain Elevation with Distributed Micro-Satellites

Distributed Small Satellites Synthetic Aperture Radar Multibaseline Interfrerometry

GMTI Performance Analysis for Distributed Satellites with InSAR Formation

Distributed Spacebased SAR System GMTI Mode Formation Optimization

System requirements and mission analysis for spaceborne sar interferometry based on formation flying satellites

New Method of Formation Design for Both GMTI and InSAR Using Distributed Satellites

Design And Maintenance Of Insar Configuration For Digital Elevation Measurement Under J(2) Perturbation

Study on DEM Generation in Satellite-Borne InSAR Formation Flying