Abstract:In a pH 5.66 acetate-acetic acid medium, the complex reaction of Al(II) with chlorophosphonazo-mS (MSCPA) is very sensitive. In order to react with Al(III) completely, MSCPA must be added excessively enough. Without doubt, the excess MSCPA in the reaction solution affected the measurement of light-absorption of the Al-MSCPA complex. Thus, ordinary spectrophotmetry is unfit for the measurement of such a complex. To eliminate such an interference, both A(537 nm), and A(618 nm) were selected as the work wavelengths and the spectral correction technique was applied to the characterization of the above complex. The result showed that the composition ratio of Al(III) to MSCPA is 1:1. Using the complexation, a new dual-wavelength approach named the light-absorption ratio variation approach (LARVA) was applied to the determination of trace amounts of Al(III), which often increases the sensitivity up to 10 times better than ordinary spectrophotometry. From the LARVA, the less the MSCPA added, the higher the sensitivity obtained. However, a too low amount of MSCPA caused an obvious error in the measurement because of the noise of instrument background. In the present work, 2.80 micromol x L(-1) MSCPA was added into the Al(III) solution. The absorbance ratio difference (deltaAr) of the Al-MSCPA solution is proportional to the Al(III) concentration in the range of 0 and 0.150 mg x mL(-1). The LOD of Al(III) is only 2 mg x L(-1). The result indicated that many kinds of metal ions did not affect the direct determination of Al(III). Besides, the addition of thiourea solution may mask Fe(III) and Cr(III) effectively. The complexation between Al(III) and MSCPA was completed in 2 min, and the color absorption of solution remained almost constant for more than 1 h. Therefore, a set of continuous flow analysis (CFA) device was designed for the online rapid analysis of Al(III) and coupled with LARVA to increase greatly the analytical efficiency. The results showed that the LOD of Al(III) is 6.5 mg x L(-1) and the analytical rate is about 30 samples per hour. This method has been applied satisfactorily to the determination of trace amounts of aluminum in two chemical reagents, giving recoveries in the range of 97.6%-103.5%.

Fluorophotometric Determination of Trace Aluminium in Mineral Water by Alizarm Red-O-phnanthroline-hydroxylammonium Chloride Color Reaction

DETERMINATION OF ALUMINIUM(III) IN MINERAL WATER BY SEMI-DIFFERENTIAL ANODIC STRIPPING VOLTAMMETRY

Fluorescence-based Method for Fast Quantification of Active Aluminums in Natural and Treated Water.

A.C. Oscillopolarographic Determination of Aluminum in Natural and Drinking Waters Using the Adsorption of the Al(III)-1,2-Dihydroxyanthraquinone-3-sulfonic Acid Complex

Improved Fluorimetric Determination of Dissolved Aluminium by Micelle-Enhanced Lumogallion Complex in Natural Waters

Determination of Aluminum Ion at Ng Ml(-1) Level in Natural Water Using Trimethoxyphenylfluorone by Light-Absorption Ratio Variation Approach

Determination of Trace Amounts of Aluminum by Light-Absorption Ratio Variation Combined with Continuous Flow Analysis

Fractionation of Aluminum in Natural Waters by Fluorometry Based on the Competitive Complexation

Development of a Fluorescent Probe for Detecting Al3+ in Cooked Wheaten Food Based on Phosphonic Acid Group Functionalized Polythiophene Derivatives.

Fast Determination of Different Forms of Aluminum in Natural Waters by A.C. Oscillochronopotentiometry Using Eriochrome Blue Black R

Determination of Aluminum in Natural Waters by Flow Injection Analysis with Spectrophotometric Detection

Catalytic spectrophotometric determination of trace aluminium with indigo carmine.

Indirect A.C. Oscillopolarographic Determination of Total Monomeric and Acid-Reactive Aluminum in Natural Waters by Using Pyrocatechol Violet

Determination of aluminum in drinking waters by a.c. oscillopolarography using solochrome violet RS

Measurement of Absorbance Ratio Difference Determination of Trace Amount of Aluminum in Surface Water with Chlorosulfophenol S As Color Reagent

Characterization of a Highly Al3+ -Selective Fluorescence Probe Based on Naphthalimide-Schiff Base and Its Application to Practical Water Samples.

A Fluorescent Probe for the Detection of Al (iii) Based on a Novel Unsymmetrical Trisubstituted 1,3,5-Triazine

[Speciation of Aluminum in Natural Waters by Fluorimetry].

Quantitative Determining Of Ultra-Trace Aluminum Ion In Environmental Samples By Liquid Phase Microextraction Assisted Anodic Stripping Voltammetry

Direct determination of trace aluminum with quercetin by reversed-phase high performance liquid chromatography.

Direct Determination of Labile Monomeric Aluminum in Natural Waters by Ac Oscillopolarography in the Presence of Rubeanic Acid