Abstract:This paper proposes a redundancy resolution algorithm for a redundant manipulator based on dynamic programming. This algorithm can compute the desired joint angles at each point on a pre-planned discrete path in Cartesian space, while ensuring that the angles, velocities, and accelerations of each joint do not exceed the manipulator's constraints. We obtain the analytical solution to the inverse kinematics problem of the manipulator using a parameterization method, transforming the redundancy resolution problem into an optimization problem of determining the parameters at each path point. The constraints on joint velocity and acceleration serve as constraints for the optimization problem. Then all feasible inverse kinematic solutions for each pose under the joint angle constraints of the manipulator are obtained through parameterization methods, and the globally optimal solution to this problem is obtained through the dynamic programming algorithm. On the other hand, if a feasible joint-space path satisfying the constraints does not exist, the proposed algorithm can compute the minimum number of breakpoints required for the path and partition the path with as few breakpoints as possible to facilitate the manipulator's operation along the path. The algorithm can also determine the optimal selection of breakpoints to minimize the global cost function, rather than simply interrupting when the manipulator is unable to continue operating. The proposed algorithm is tested using a manipulator produced by a certain manufacturer, demonstrating the effectiveness of the algorithm.

Kinematic and Torque Distribution of Redundant Robot with Locked Joint Failures

Adaptive Robust Posture Control of A Pneumatic Muscles Driven Parallel Manipulator with Redundancy

On the Virtual Joints for Kinematic Control of Redundant Manipulators with Multiple Constraints

A Discrete Model-Free Scheme for Fault Tolerant Tracking Control of Redundant Manipulators

Kinematic and Dynamic Models of Hyper-Redundant Manipulator Based on Link Eigenvectors

Kinetostatics of a Snake Robot with Redundant Degrees of Freedom

Kinematic Analysis and Fault-Tolerant Trajectory Planning of Space Manipulator under a Single Joint Failure

Neural Dynamic Fault-Tolerant Scheme for Collaborative Motion Planning of Dual-Redundant Robot Manipulators.

A unified dynamic control method for a redundant dual arm robot

Redundancy Resolution and Disturbance Rejection via Torque Optimization in Hybrid Cable-Driven Robots

Multi-Task Learning of Active Fault-Tolerant Controller for Leg Failures in Quadruped robots

Redundancy Resolution in Kinematic Control of Serial Manipulators in Multi-Obstacle Environment

Accurate Position and Posture Control of a Redundant Hexapod Robot

Reinforcement Learning-based Fault-Tolerant Control of Robot Arms.

Adaptive Fuzzy Event-Triggered Control for Single-Link Flexible-Joint Robots With Actuator Failures

Human-redundant robot interaction and redundancy utilization based on three-dimensional force sensor

The Dynamic Modeling, Redundant-Force Optimization, and Dynamic Performance Analyses of A Parallel Kinematic Machine with Actuation Redundancy

Dynamic Programming-Based Redundancy Resolution for Path Planning of Redundant Manipulators Considering Breakpoints

Dynamics and Control of a Novel 3 -DOF Parallel Manipulator with Actuation Redundancy.

Real-time optimized inverse kinematics of redundant robots under inequality constraints

Kinetostatic Optimization for Kinematic Redundancy Planning of Nimbl'Bot Robot