STUDY ON MICRO-DETERMINATION OF 1, 4-BIS (TRICHLOROMETHYL) BENZENE
Tao Yao
1980-01-01
Abstract:In the past ten years or so, Hetol, 1, 4-bis(trichloromethyl)benzene or hexachlorop-xylene (HCX), has been widely used in many fields and particular in therapy as a parasiticide. In order to monitor its accumulation in the body a rapid, sensitive and convenient method for quantitative micro determination of this compound needs to be established. D. Katz reported in 1964 that an acetone solution of diphenylamine and zinc chloride develops color with chlorocompounds in thin layer chromatography. We have found that dimethylaniline reacts with HCX in the presence of anhydrous zinc chloride on heating to yield a bluish-green product which is soluble in acetone and has a maximum absorption at 624 nm. Measurement of the absorbance at 624 nm of this bluish green acetone solution thus provides a means for the determination of the compound on a micro scale.This spectrophotometric method can be applied to samples of whole blood, serum and most of animal tissues or organs, such as heart, brain, kidney, liver, but is not suitable for feces due to interfering substances. Standard solutions were prepared first by dissolving 50.0 mg of pure HCX, in 100ml benzene at 20±0.5℃, so as to give a 500γ/ml stock solution, and then by diluting this stock solution with benzene to a series of working standards containing 1～30γ/ml of the compound. Two reagents were used for producing the bluish-green product: one was a 2.0％ (V/V) dimethyl-aniline solution in acetone, which should be kept in brown bottle and is stable for about 1/2 month, and the other was a 2％ (W/V) solution of anhydrous zinc chloride in acetone, which is quite stable for a long period.In case of biological samples, it is necessary to extract the HCX with benzene first. For instance, put 0.5ml of blood sample into a glass stoppered centrifuge tube, add 3ml of benzene, shake at room temperature for 20 minutes, let it stand for some time and centrifuge. Pipet carefully 2ml of the benzene solution. Develop the color and measure the absorbance.Experiments showed that when using a definite amount of dimethylaniline the optical density reaches a plateau if the amount of zinc chloride solution used is greater than 0.4ml of 1％ solution. The fact that the optimum temperature for the color reaction was found to be that of boiling water, and the time for completing the color reaction was found to be within 2～4 minutes after heating, 6 minutes was chosen as the heating time in order to ensure the completion of the color formation. Besides acetone, 20％ acetic acid can also be used as solvent, but the slope of the working curve obtained was not as steep, Nearly 100％ recovery can be obtained. This method is quite sensitive, as 0.1γ of HCX in the benzene extract,corresponding to an optical density of 0.003, can be detected. The standard deviation was calculated to be 0.24, while the variation coefficient was 2.28％. The mechanism of this color reaction was studied by mole-ratio method and the gram molecular ratio of dimethylaniline to HCX was found to be approximately 6:1(Fig. 5),hence the reaction may proceed by way of a Friedel-Crafts alkylation.