Abstract:Software-Defined Networking (SDN) technology has emerged as a promising solution to guarantee high reliability in the Industrial Internet of Things (IIoT) ecosystem. Through SDN, both fault tolerance-based Route Protection (RP) and fault tolerance-based Route Restoration (RR) are available to provide traffic rerouting when a network failure occurs in IIoT. RR redefines routes dynamically based on the current network status. However, it increases significantly the recovery time, which is not suitable for the Quality-of-Service (QoS) requirements of IIoT. In contrary, RP ensures fast failover, but it cannot be updated when the network status changes until the timeout interval expires. To deal with these issues, we propose a Dynamic Route Protection (DRP) mechanism that recalculates and reinstalls new optimal link-disjoint routes in accordance with the change rather than awaiting the controller to retransmit new flow instructions. Moreover, DRP responds speedily to forward the data packets from the secondary route to the main route if it is repaired. To recover rapidly when the connection failure affects both a link on the main route and the link on the secondary route simultaneously, the DRP mechanism utilizes the strategy of caching the third route in the controller memory using the Dynamic Hash Table (DHT) structure. DRP considers the heterogeneous traffic flows such as either delay-sensitive or both delay-sensitive and loss-sensitive. Again, this paper introduces a candidate fault tolerance architecture for Software-Defined IIoT (SDIIoT) that decouples IIoT networks into three functional layers. The results from the simulation network and the experimental hardware testbed illustrated that the DRP mechanism outperforms the FT-RP, RR, LFR, Pro-VLAN, and SDNRMbw mechanisms by minimizing the failure recovery time, end-to-end delay, packet violation rate, packet loss rate, and the time required to reuse the main route when it is repaired, while maximizing the packet delivery ratio.

Research on Distributed Network Fault Detection and Recovery Technique

Fault Detection and Recovery Technology Performance Analysis of Distributed Ring Network

Investigation on Compatible Remote Fault Diagnosis System for Power Electronic Equipments

Industrial Wireless Network Real-time and Reliable Routing Algorithm Based on EPA

Fault Detection and Isolation Methods in Subsea Observation Networks

Self-adaptive Failure Detector for Peer-to-Peer Distributed System Considering the Link Faults

A New Fault Detection Method for Computer Networks

Fast Connection Recovery Against Region Failures with Landmark-Based Source Routing

Fault detection of networked dynamical systems: a survey of trends and techniques

Stability Evaluation of Ring Networked Control Systems Based on DRP Protocol

An adaptive distance protection scheme considering fault resistance, injected current, and structural changes in the power system

Resilient Sensor Data Dissemination to Mitigate Link Faults in IoT Networks With Long-Haul Optical Wires for Power Transmission Grids

Application-Oriented Fault Detection and Recovery Algorithm for Wireless Sensor and Actor Networks

Optimal Service Restoration and Adaptive Switching of Tie Switches Method of Distributed Self-healing Control in Distribution Systems

DRTP: A Disruption Resilient Hop-by-Hop Transport Protocol for Synchrophasors Measurement in Electric Transmission Grids

Research on Power Supply Recovery Scheme Based on Distributed Intelligence

Industrial IoT regulated by Software-Defined Networking platform for fast and dynamic fault tolerance application

Resilience Enhancement Strategies for Active Distribution Grid Fault Recovery in Collaboration with Dynamic Network Reconfiguration

Performance Testing and Analysis of Multi-vendor IEDs under PRP Configuration

Communication Network Structure of Digital Substation Based on Parallel Redundancy

Distributed relay protection for distribution network based on hybrid power method and current method