Abstract:The internal flow evolution of the pump was induced with impeller movement. In various conditions, the peak load on centrifugal blade under the change of rotational speed or flow rate was also changed. It would cause an error when inertia load with a safety coefficient (that was difficult to ascertain) was applied in structure design. In order to accurately analyze the impeller stress under various conditions and improve the reliability of pump, based on a mixed flow pump model, the stress distribution characteristic was analyzed under different flow rates and rotational speeds. Based on a three-dimensional calculation model including impeller, guide blade, inlet and outlet, the three-dimension incompressible turbulence flow in the centrifugal pump was simulated by using the standard k-epsilon turbulence model. Based on the sequentially coupled simulation approach, a three-dimensional finite element model of impeller was established, and the fluid-structure interaction method of the blade load transfer was discussed. The blades pressure from flow simulation, together with inertia force acting on the blade, was used as the blade loading on solid surface. The Finite Element Method (FEM) was used to calculate the stress distribution of the blade respectively under inertia load, or fluid load, or combined load. The results showed that the blade stress changed with flow rate and rotational speed. In all cases, the maximum stress on the blade appeared on the pressure side near the hub, and the maximum static stress increased with the decreasing of the flow rate and the increasing of rotational speed. There was a big difference on the static stress when inertia load, fluid load and combined loads was applied respectively. In order to more accurately calculate the stress distribution, the structure analysis should be conducted due to combined loads. The results could provide basis for the stress analysis and structure optimization of pump.

Strength Evaluation of the Composite Propeller under Hydrodynamic Fluid Load

Simulation of dynamical loads for large controllable pitch propellers ground tests

Evaluation and analysis of the static strength of ice-class propellers

Micromechanics-based Progressive Failure Analysis of Carbon FIber/epoxy Composite Vessel under Combined Internal Pressure and Thermomechanical Loading

Fluid-Solid Coupling Analysis of the Propeller and Optimization of Boss Cap Fin Parameters

Structural design of the composite blades for a marine ducted propeller based on a two-way fluid-structure interaction method

Numerical study of the hydrodynamic performances of surface piercing propeller

DESIGN AND ANALYSIS OF COMPOSITE PROPELLER BLADE FOR AIRCRAFT

Computation of Stress Distribution in a Mixed Flow Pump Based on Fluid-Structure Interaction Analysis

3D Multiscale Dynamic Analysis of Offshore Wind Turbine Blade under Fully Coupled Loads

Analysis of Aerodynamic Load of LSU-03 (LAPAN Surveillance UAV-03) Propeller

THE STRUCTURAL ANALYSIS METHOD OF WIND TURBINE BLADE BASED ON MECHANICS OF COMPOSITE MATERIALS

Multi-component Optimization of Composite Pump-Jet Propulsor Based on Sensitivity Analysis

Parameterized design method and verification of propeller single-passage domain

Micromechanics-based Burst Failure Analysis of Composite Vessel Used for Hydrogen Storage

A Comparison of Physical and Numerical Modeling of Homogenous Isotropic Propeller Blades

Simulation studies around the steering system of the azimuthing propulsor

Numerical analysis on dynamic behaviors of coupled propeller-shafting system of underwater vehicles

Prediction Method and Characteristics of Static Acoustic Scattering for Marine Composite Propellers

Tip clearance influence on hydrodynamic performance and pressure fluctuation of a composite ducted propeller using a two-way FSI method

INVESTIGATION OF STRENGTH PROPERTIES OF IMPELLERS MADE OF COMPOSITE MATERIAL FOR DIESEL ENGINES