Abstract:Combustion system development in power generation is discussed ranging from the pre-environmental era in which the objectives were complete combustion with a minimum of excess air and the capability of scale up to increased boiler unit performances, through the environmental era (1970–), in which reduction of combustion generated pollution was gaining increasing importance, to the present and near future in which a combination of clean combustion and high thermodynamic efficiency is considered to be necessary to satisfy demands for CO2 emissions mitigation.From the 1970s on, attention has increasingly turned towards emission control technologies for the reduction of oxides of nitrogen and sulfur, the so-called acid rain precursors. By a better understanding of the NOx formation and destruction mechanisms in flames, it has become possible to reduce significantly their emissions via combustion process modifications, e.g. by maintaining sequentially fuel-rich and fuel-lean combustion zones in a burner flame or in the combustion chamber, or by injecting a hydrocarbon rich fuel into the NOx bearing combustion products of a primary fuel such as coal.Sulfur capture in the combustion process proved to be more difficult because calcium sulfate, the reaction product of SO2 and additive lime, is unstable at the high temperature of pulverized coal combustion. It is possible to retain sulfur by the application of fluidized combustion in which coal burns at much reduced combustion temperatures. Fluidized bed combustion is, however, primarily intended for the utilization of low grade, low volatile coals in smaller capacity units, which leaves the task of sulfur capture for the majority of coal fired boilers to flue gas desulfurization.During the last decade, several new factors emerged which influenced the development of combustion for power generation. CO2 emission control is gaining increasing acceptance as a result of the international greenhouse gas debate. This is adding the task of raising the thermodynamic efficiency of the power generating cycle to the existing demands for reduced pollutant emission. Reassessments of the long-term availability of natural gas, and the development of low NOx and highly efficient gas turbine–steam combined cycles made this mode of power generation greatly attractive also for base load operation.However, the real prize and challenge of power generation R&D remains to be the development of highly efficient and clean coal-fired systems. The most promising of these include pulverized coal combustion in a supercritical steam boiler, pressurized fluid bed combustion without or with topping combustion, air heater gas turbine-steam combined cycle, and integrated gasification combined cycle. In the longer term, catalytic combustion in gas turbines and coal gasification-fuel cell systems hold out promise for even lower emissions and higher thermodynamic cycle efficiency. The present state of these advanced power-generating cycles together with their potential for application in the near future is discussed, and the key role of combustion science and technology as a guide in their continuing development highlighted.

Latest Advances in Fundamental Research on Air-separation/Flue Gas Recycling Technology

Measurements and Modelling of Oxy-Fuel Coal Combustion

A review on fundmental research of oxy-coal combustion technology

Study on Pollutant Emission Characteristics From Oxy-fuel Combustion of Coal With Recycled Flue Gas

Recent Progress in Research on Efficient Low Polluting Combustion and Gasification Technology

(Invited) Elevated Temperature CO2 Adsorption Separation and Electrochemical Conversion：Reaction Mechanism and Technology Development

Experimental Research on Pollutant Emission of Coal Combustion in a Circulating Fluidized Bed Test-Facility under O2/CO2 Atmosphere

Progress in the Study of Removal from Coal Fired Flue Gas by Microalgae

A critical review on current progress and challenges in post-combustion CO2 separation from flue gas

Current advances and future prospects of in-situ desulfurization processes in oxy-fuel combustion reactors

Fundamental and Technical Challenges for a Compatible Design Scheme of Oxyfuel Combustion Technology

Carbon Dioxide Separation from Flue Gases: A Technological Review Emphasizing Reduction in Greenhouse Gas Emissions

Drugs in crops (continued)

Experimental Study And Analysis Of Coal Combustion On A Cfb Test-Facility In O-2/Co2 And O-2/N-2 Mixtures

Gas Oxy Combustion and Conversion Technologies for Low Carbon Energy: Fundamentals, Modeling and Reactors

TEST STUDY ON AND ANALYSIS OF BURNING BEHAVIOR FOR COAL UNDER ATMOPHERE OF O2/CO2

Oxyfuel Combustion Makes Carbon Capture More Efficient

Review on research and development of oxy-coal burner for carbon capture

Advancements and Future Outlook in Fundamental Research and Technological Applications for Ammonia Co-Firing with Coal

Combustion technology developments in power generation in response to environmental challenges

Tumour necrosis factor-alpha, resting energy expenditure and cachexia in cystic fibrosis.