Abstract:A 600-700GHz SIS mixer with the twin-junction tuning circuit has been designed and fabricated [1] The surface impedance of thin-film superconducting microstrip lines, based on Mattis-Bardeen theory [2], is included in the optimization of RF impedance matching. The receiver noise temperature measured in the frequency range of 630-660GHz is below 200K and the lowest receiver noise temperature of 181K is achieved at 656GHz. The FTS response of the SIS mixer shows a good RF coupling from 600GHz to 700GHz. Both the noise performance and the FTS response can be quantitatively described by numerical results using the quantum theory of mixing. Some detail considerations on the mixer model calculation, such as spreading inductance around the junction tuning structure and mixer's embedding impedance, are discussed. Introduction Nb-based superconductor-insulator-superconductor (SIS) mixers have been used very successfully in sub-mm wavelength detection. Their receiver noise temperature has reached to three times the quantum limit, —3 hfrkB, below the junction's gap frequency. However, at high frequency bands, Nb SIS mixers need to be designed carefully because the photon energy is close to or higher than the gap energy of Nb, A-1.4meV. When the frequency band covers the gap frequency of Nb, —670GHz, the RF loss of Nb superconducting transmission lines increases dramatically and the surface impedance has strong frequency dependence. Usually, the RF properties of a superconducting transmission line can be described by the Mattis-Bardeen theory [2] in good accuracy. From results reported so far [4-9], the best receiver noise temperature is close to 5 hi7kB in the band of 600-700GHz. Despite of the input loss contributed by the experimental setup, some other properties of SIS mixers should be taken into account. In this paper, we characterize the performance of a 600-700GHz mixer by comparing the experimental and simulated results.

Superconducting SIS Mixers with Vertically Stacke D Junctions

Noise Performance of a 200–280 GHz Mixer with Nb-AlN-NbN Superconducting Tunnel Junctions

Noise and Bandwidth of 0.5-Thz Twin Vertically Stacked SIS Junctions

Performance of a 500 GHz SIS mixer with a distributed junction array

Performance Characterization of a 600-700 GHz SIS Mixer

A Novel Mm-Wave SIS Mixer Comprising Series-Connected Junction Array and On-Chip Bias-T

Measurement of the direct-detection responses of a 500-GHz and a 660-GHz waveguide superconducting SIS mixer

Operation of Mixer Comprising a Series-Connected Distributed Superconductor–Insulator–Superconductor Junction Array

0.5-Thz Waveguide Sis Mixers with Nbn/Aln/Nbn Technology

Development Of A 0.5-Thz Waveguide Nbn-Based Sis Mixer

Characterization of the Mixing Performance of All-NbN Superconducting Tunnel <newline/>Junctions at 0.5 THz

A Quantum-Limited Submillimeter Mixer with an Inhomogeneous Distributed SIS Junction Array

Mixing Properties of Nbn-Based Sis Mixers with Nbtin Wirings

An Anomalous Peak on Intermediate Frequency Response of Superconductor-Isolator-Superconductor Mixers and Its Effect on Mixing Performance

Fabrication of Superconductor Integrated Circuits of D-Band Dual-Polarization Balanced SIS Mixers

A self-pumped high-temperature superconducting Josephson mixer: Modelling and measurement

Terahertz high-sensitivity SIS mixer based on Nb-AlN-NbN hybrid superconducting tunnel junctions

A 385-500 GHz Low Noise Superconductor-Insulator- Superconductor Mixer for ALMA Band 8.

Development of an All-NbN Waveguide SIS Mixer for 0.5 THz

Comparison of the performance of a 0.5-THz Nb and NbN superconducting SIS mixer

A THz SIS Mixer with a NbTiN-Ground Plane and SIS Microtrilayers Directly Grown on a Quartz Substrate